Cub Cadet Z-Force S 46 Operator's Manual page 14

Choke Control
The choke knob controls the position of the
engine choke and is located on the RH console.
Pull the knob out to choke the engine; push the
knob in to open the choke.
Parking Brake Engagement Lever
The parking brake engagement lever is located on the left
of the seat box frame, and is used to engage the parking
brake.
Pull the lever reward to stop the tractor or slow it down.
Pull the lever fully rearward and to the right; then into the
short "J" slot to engage the brake.
Pull the lever up out of the "J" slot and to the left; then
completely forward to disengage the parking brake.
Drive Pedal
The drive pedal is located on the right side
of the tractor, along the running board. Press
the drive pedal forward to cause the tractor to
travel forward. Ground speed is also controlled
with the drive pedal. The further forward the
pedal is pivoted, the faster the tractor will travel. The pedal will
return to its original position when it's not pressed.
Reverse Pedal
The reverse pedal is located on the right
side of the tractor along the running board.
Ground speed is also controlled with the
reverse pedal. The further downward the
pedal is pivoted, the faster the tractor will
travel. The pedal will return to its original
position when it's not pressed.
14 s 4— c
ectiOn OntrOls
CHOKE
& f
eatures
Cup Holder
The cup holder is located on the LH console to the left of the
operator's seat.
Storage Tray
The storage tray is located at the rear of the LH console.
Seat Adjustment Lever
The seat adjustment lever is located below the front/right of the
seat. The lever allows for adjustment of the fore to aft position of
the operator's seat. Refer to the Assembly & Set-Up section for
instructions on adjusting the seat position.
Steering Tilt Pedal
The steering tilt pedal is located at the bas of
the steering column. To increase or decrease
the angle of the steering column press down on
the steering tilt pedal, move the steering wheel
column to the desired position and release the
pedal.
REVISIONS
REV DESCRIPTION
T00 Release For Tooling