Philips PD7013 Service Manual
Hide thumbs
Also See for PD7013:
- User manual (27 pages) ,
- Specifications (3 pages) ,
- Quick start manual (2 pages)
Advertisement
Quick Links
DVD Portable
Service Manual
TABLE OF CONTENTS
Technical Specification, PCBs Location....................... 1
Safety Instruction ...................................................... 2
Instruction for Use...................................................... 3
Mechanical and Dismantling Instructions...................... 4
Service Modes, Troubleshooting.................................. 5
Overall Block Diagram, Wiring Diagram......................... 6
Electrical Diagram...................................................... 7
Exploded View Diagram & Service Part List....................8
Revision List............................................................. 9
Copyright 2009 Philips Consumer Electronics B.V. Eindhoven, The Netherlands
All rights reserved. No part of this publication may by reproduced, stored in a retrieval system or
transmitted, in any form or by any means, electronics, mechanical, photocopying, or otherwise
without the prior permission of Philips.
Published by BL AVM
Version
3.0
Printed in the Netherlands
PD7013/55/79/77
Chapter
Subject to modification
Advertisement
Related Manuals for Philips PD7013
Summary of Contents for Philips PD7013
- Page 1 Exploded View Diagram & Service Part List………………..8 Revision List……………………………………………………. 9 Copyright 2009 Philips Consumer Electronics B.V. Eindhoven, The Netherlands All rights reserved. No part of this publication may by reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronics, mechanical, photocopying, or otherwise without the prior permission of Philips.
- Page 2 1.0 TECHNICAL SPECIFICATION VIDEO/ AUDIO Characteristic Testing discs Test discs DOLBY: Dolby Test disc ABEX: TDV-540A VIDEO FORMAT DVD / SVCD / JPEG / MPEG4 / DIVX3, 4,5,6(Home theater) AUDIO FORMAT CD / MP3(32 - 320 kbps) Video (PAL / NTSC) White bar : 714mV +10%/-20% Sync.
- Page 3 1.1 PCBs Location VERSION VARIATIONS Type/Versions: PD7013 Service policy Board in used: MAIN BOARD KEY BOARD TFT BOARD *TIPS: C -- Component Lever Repair. M -- Module Lever Repair X -- OCX...
- Page 4 5. Refer below table for your region code setting Procedure for SW upgrade 1. The upgrade will provide a document re-named: PHILIPS.BIN 2. “PHILIPS.BIN” copy to CD-ROM into the data; 3. Reading the CD-ROM in accordance with prompt press ”OK” key to upgrade...
- Page 5 2.0 SAFTETY INSTRUCTIONS WAARSCHUWING WARNING Alle IC’s en vele andere halfgeleiders zijn All ICs and many other semi-conductors are gevoelig voor electrostatische ontladingen susceptible to electrostatic discharges (ESD). (ESD). Careless handling during repair can reduce life Onzorgvuldig behandelen tijdens reparatie kan drastically.
- Page 6 2.1 ESD PROTECTION When the power supply is being turned on, you may not remove this laser cautions label. If it removes, radiation of laser may be received. PREPARATION OF SERVICING Pickup Head consists of a laser diode that is very susceptible to external static electrocity. Although it operates properly after replacement, if it was subject to electrostatic discharge during replacement, its life might be shortened.
- Page 7 SAFTY NOTICE SAFTY PRECAUTIONS LEAKAGE CURRENT CHECK Plug the AC line cord directly into a 120V AC outlet (do Measure the AC voltage across the 1500 resistor. not use an isolation transformer for this check). Use an The test must be conducted with the AC switch on and AC voltmeter, having 5000 per volt or more sensitivity.
- Page 8 2.2 SAFETY INSTRUCTIONS Battery Handling Guideline Since the battery is packed in soft package, to ensure its better performance, it’s very important to carefully handle the battery 2.2.1 Soft Aluminium foil The soft aluminum packing foil is very easily damaged by sharp edge parts such as Ni-tabs, pins and needles. Don’t strike battery with any sharp edge parts Trim your nail or wear glove before taking battery Clean worktable to make sure no any sharp particle...
- Page 9 3.0 Instruction for Use You can download this information from the following websites: http://www.philips.com/support http://www.p4c.philips.com...
- Page 10 4.0 MECHANICAL INSTRUCTION The following guidelines show how to dismantle the protable Step1:Remove screws to remove base Step4:Remove top cover Step2:Open the DVD base Step5: Remove screws to remove PCBAs Step3: Remove DVD driver and every PCB board...
- Page 11 5.0 TROUBLESHOOTING SYMPTOM: NO IMAGE / NO SOUND SYMPTOM: NO IMAGE OUTPUT ( THE PANEL SHOW BLUE PICTURE) Start Check DVD Drive work? Replace DVD Drive Check the external AV NOTE: AV Cable TYPE from outside to note Cable TYPE Exchange AV cable Inside L-Audio, R-Audio, Video, Ground connection is OK?
- Page 12 5.0 TROUBLESHOOTING SYMPTOM: THE DVD DRIVE DOES NOT WORK SYMPTOM: THE DVD DRIVE DOESN T WORK Start Check DVD-Loader Cable Reinsertion connection OK? Check the DVD-Loader Replace DVD- Loader Replace main board...
- Page 13 5.0 TROUBLESHOOTING SYMPTOM: ADAPTOR CANNOT POWER ON Adaptor can not Power ON Start Check Adaptor OK? Change adaptor SET OK? Check the Power-ON Return set to Replace Main Board button and cable OK? Customer Replace Button or Cable...
- Page 14 5.0 TROUBLESHOOTING SYMPTOM: KEY & BOTTON FAILURE SYMPTOM: Key & Botton Fail Start Check CABLE form board to Cable Reinsertion board connection OK? Check KEY board OK? Replace KEY board Replace main board Return to custormer...
- Page 15 OVERALL BLOCK DIAGRAM AV OUT JACK TFT PANNEL L/R AND CVBS BACK LIGHT LG J2 EARPHONE Power input 9~15V AMPLIFIER SPEAKER 0.3WX2 DC-DC MPEG DECODER MOTOR DRIVER LOADER(SANYO SPHE8202 SP850) SW5888 CONTROL SPI FLASH SDRAM 4X16...
- Page 16 CIRCUIT DIAGRAM-MAIN BOARD DCDC_5V VCOM_5V 22uH EC28 10uF 8.2K 100K PGND PANEL_VGL SSD03 U10 SS6610 NJM3414 P_DC_COM P_AC_COM 4.7K O/P_A EC27 R132 PANEL_VCOM -I/P_A O/P_B LED+ R108 PGND +I/P_A -I/P_B 100uF/10V 100nF 10uF/16V EC12 +I/P_B LED- R134 2.4K 10uF/16V VCOM 100R PANEL_VGL PGND...
- Page 17 CIRCUIT DIAGRAM-MAIN BOARD DVCC3 A+5V P+5V Servo analog +5V 2.2_0805 battery charge DIP4P/1.25L 100nF FB120R SPI Flash +3.3V CHARGE SPI_VCC3 +9VDCIN RFGND SOT23_213 TP50 M+5V 4148-A Servo MOTOR +5V RED_LED 4148-A FB600R B-CHARGE 100R/NC 100nF R22 4.7K TP69 R_0402 3904 SOT-23-123 TP70 RFGND...
- Page 18 CIRCUIT DIAGRAM-MAIN BOARD P_P+3V3 P_P+3V3 TP13 TP14 TP15 TP12 1N4148 P_P+3V3 P_KEY0 P_KEY0 CON5/1.25MM/DIP 1N4148 P_KEY1 P_KEY1 P_KEY2 P_KEY2 P_KEY3 P_KEY3 P_P+3V3 TO KEY BOARD PGND IN TFT BOARD...
- Page 19 CIRCUIT DIAGRAM-MAIN BOARD B/U_ CVBS A+5V A+5V CVBS RFGND G/Y_ R/V_ P_STHL_ P_STHL P_OEH_ P_OEH A+5V EC15 P_OEV_ P_OEV P_CKV_ P_CKV FOC- 100uF_10V 0.1uF DVCC3 FOC+ /LDSW P_STVU_ P_STVU RAD+ DC_COM_ DC_COM IR_TEXT RAD- AC_COM_ AC_COM RFGND IR_IN_ IR_IN 100R BACKL_EN_ BACKL_EN close to connector...
- Page 20 CIRCUIT DIAGRAM-MAIN BOARD EON25T16 SPI_CE SPI_VCC3 SPI_HOLD M_A0 M_D0 /HOLD SPI_WP SPI_CLK_1 M_A1 M_D1 M_A2 M_D2 M_A3 M_D3 M_A4 M_D4 M_A5 M_D5 M_A6 M_D6 M_A7 M_D7 M_A8 M_D8 M_A9 M_D9 M_A10 M_D10 A10/AP M_A11 M_D11 M_DQM0 M_D12 LDQM M_DQM1 M_D13 UDQM M_WE M_D14...
- Page 21 CIRCUIT DIAGRAM-MAIN BOARD 100pF DC_IN AU_OP EC35 AOUT_L R105 5.1K EC33 EC32 360R L_OUT 10uF_16V 10uF_16V 0.1uF 10uF_16V U11A 1000P 1000pF NJM4558 VREF3 100K 820pF AU_OP AU_OP R101 R102 100pF VREF3 EC36 EC31 R106 L_OUT AOUT_R R107 5.1K R108 R109 EC37 R110 360R...
- Page 22 CIRCUIT DIAGRAM-KEY BOARD 1N4148 K_GND IN KEY BOARD K_GND...
- Page 25 7-10...
- Page 26 7-11...
- Page 27 7-12...
- Page 28 7-13...
- Page 29 8.0 Exploded View Diagram...
- Page 30 9.0 REVISION LIST Version 1.0 Initial release Version 2.0 Add version /79 Version 3.0 Add version /77...