Troubleshooting; Indicators And Projector Condition - Sanyo PDG-DXL2000 Service Manual

Troubleshooting

Indicators and Projector Condition

Check the indicators for projector condition.
Indicators
WARNING
POWER
TEMP
red/green
red
j j
J
j
red
J
j
green
K
j
red
K
j
green
J
j
green
K
K
red
J
K
red
j J
J
j
green
J
• • • on
] /v
• • • Differs according to conditions
LAMP RE- 3D
PLACE
yellow blue
j j
The projector is off. (The AC power cord is unplugged.)
The projector is in stand-by mode. Press the ON/STAND-
]
v
BY button to turn on the projector.
]
v
The projector is operating normally.
The projector is preparing for stand-by or the projection lamp
is being cooled down. The projector cannot be turned on
]
v
until cooling is completed and the POWER indicator stops
blinking.
]
v
The projector is in the Power management mode.
J
]
The projector is in 3D display mode.
The temperature inside the projector is abnormally high.
The projector cannot be turned on. When the projector is
cooled down enough and the temperature returns to normal,
]
v
the POWER indicator stops blinking and the projector can
be turned on. (The WARNING TEMP indicator keeps blink-
ing.)
The projector has been cooled down enough and the tem-
]
v perature returns to normal. When turning on the projector,
the WARNING TEMP indicator stops blinking.
The projector detects an abnormal condition and cannot be
turned on. Unplug the AC power cord and plug it again to
turn on the projector. If the projector is turned off again, un-
]
v
plug the AC power cord and contact the dealer or the service
center for service and checkup. Do not leave the projector
on. It may cause an electric shock or a fire hazard.
The lamp has been used overtime. Replace the lamp imme-
J
v diately and then reset the lamp counter. The indicator will be
turned off after resetting the counter.
K
• • • blinking
Projector Condition
j
• • • off
-38-