Panasonic DMR-BWT820 Operating Instructions Manual page 13

Main unit


1 Standby/on switch (Í/I)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
2 Recording indicator
• The indicator will light up while recording.
• The indicator will blink while recording is
paused and before recording starts.
3 CALL LED
• The LED will light up when this unit receives
incoming call etc. of the video
communication. (
4 Remote control signal sensor
• Angle: Approx. 20° up and down, 30° left and
right
• Distance: Within approx. 7 m in front of the
unit
5 Open/close disc tray
6 Disc tray
7 USB port
8 SD card slot
• When removing the SD card, press on the
centre of the card and pull it straight out.
9 Channel select ( 24)
: Start recording ( 28)
; Stop
< Start play
= [BWT820] Blue LED
• It is possible to set the LED to turn on/off.
( 87, Blue LED)
Press [< OPEN/CLOSE] to open the tray and insert or remove a disc.

USB memory
SD card
75)
 

Pull to flip down
 
the front panel.
> Display
HDDSD
BD
4 5
1 SD card slot indicator
2 Copying indicator
3 Disc indicator
4 Drive (HDD, BD or SD) indicator
5 Remote control signal indicator
6 Main display section indicator
- Current time
- Playback counter
- Various messages (
7 Playback indicator
8 USB port indicator
9 Timer recording indicator
• This indicator lights up when the timer
recording standby is activated.
• While writing to/reading from the media, do not switch the
unit to standby mode or remove the media. Such action
may result in loss of the media contents.
• When inserting the media, ensure that it is facing the right
way up.
Getting started
 
   
1
COPY
SD USB
PLAY
6 7 8
102)
VQT4C68
2 3
9
13