Air Purifier Care; Cleaning; Filter Replacement; Troubleshooting - Whirlpool WHISPURE Use & Care Manual

Hide thumbs Also See for WHISPURE:
Table of Contents

Advertisement

Available languages

Available languages

AIR PURIFIER CARE

Cleaning

3
1. Release tabs
4. Pre-filter
2. Controls
5. HEPA filter
3. Front grille
1. Press POWER to turn the air purifier off.
2. Unplug air purifier or disconnect power.
3. Place fingers on the front release tabs. Gently push the tabs
in and pull the front grille forward to remove it.
4. Remove both filters and set aside. Do not try to wash and
reuse either the HEPA filter or the pre-filter.
5. Clean the air purifier with a soft, damp cloth.
6. Gently wash the front grille in soapy water.
NOTE: The grille is not dishwasher safe.
7. Reassemble the filters as shown in previous illustration.
8. Place the bottom tabs on the front grille into the bottom slots
in base of the air purifier. Push the top of the grille forward
until the grille locks into place.
9. Plug in air purifier or reconnect power.
10. Press POWER to start the air purifier.
1
2
1
4
5
7
6
6. Bottom slot
7. Mainframe
assembly

Filter Replacement

NOTE: The filter indicator lights on top of the air purifier will glow
when it is time to replace either the pre-filter or the HEPA filter.
For the most efficient operation of the air purifier, it is
recommended that you replace the pre-filter every three months
and the HEPA filter every year. See "Replacement Filters" in the
"Assistance or Service" section.
1. Press POWER to turn the air purifier off.
2. Unplug air purifier or disconnect power.
3. Place fingers on the front release tabs. Gently push the tabs
in and pull the front grille forward to remove it.
4. Remove and replace the indicated filter. Install the new HEPA
filter in the same direction shown by the arrow located on the
filter frame. Install the new pre-filter by placing it on the tabs.
NOTE: Do not try to wash and reuse either the HEPA filter or
the pre-filter.
5. Place the bottom tabs on the front grille into slots in the base
of the air purifier. Push the top of the grille forward until the
grille locks into place.
6. Plug in air purifier or reconnect power.
7. Press POWER to start the air purifier.
8. Press either the PRE-FILTER RESET and/or the HEPA RESET
button for 5 seconds to turn off the filter indicator light(s) and
reset timer.

TROUBLESHOOTING

First try the solutions suggested here and possibly avoid
the cost of a service call...
Air purifier will not run
Check the following:
Is the air purifier turned on?
Is the power cord plugged into a grounded 3 prong outlet?
Has a fuse blown or has the circuit breaker tripped?
Was a regular fuse used? Use a time-delay fuse or time-delay
circuit breaker.
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ap51030l

Table of Contents