Samsung DW80H997 Series User Manual page 27

PROBLEM
Does not dry dishes
well.
Has a bad odor.
Is too noisy.
Does not have a
smoothly rotating
nozzle.
Water won't
pump out of the
dishwasher.
Has a bent upper
rack after loading
dishes.
DW80H9950-00149A-03_EN_140811.indd Sec7:27 DW80H9950-00149A-03_EN_140811.indd Sec7:27
POSSIBLE CAUSE
There is no rinse aid in the
dispenser.
The temperature of the water
is low when the dishwasher is
running.
Too many dishes have been
loaded.
Glasses and cups with concave
bottoms hold water. This water
may spill onto other items when
unloading.
Water was left over from an
incomplete cycle.
The Drain Hose is obstructed.
The dishwasher is not used daily
or soiled dishes are left in unit too
long.
Sound is generated when the
dispenser cover is open and the
drain pump is operating in an early
stage.
The dishwasher is not level.
Foreign material (a screw, a plastic
piece) is in the pump chamber.
There is a 'chopping' sound
because a nozzle is bumping
against the dishes.
The nozzle hole is clogged with
food particles.
The nozzle is blocked by a dish or
pot and cannot rotate.
The drain is clogged.
The dishes are not loaded
properly.
English - 27
SOLUTION
Check the dispenser and add rinse aid.
Use a liquid type rinse aid.
Connect the water supply line to a hot
water supply.
Use rinse aid with the Sanitize option.
Proper loading of items can affect drying.
Load your dishes as recommended.
(See page 16.)
After fi nishing the cycle, empty the lower
rack fi rst and then the upper rack. This will
prevent water dripping from the upper rack
onto the dishes in the lower rack.
Insert detergent without loading dishes,
and run the Normal cycle to clean the
dishwasher.
Contact a qualifi ed service technician to
remove any obstruction from the drain
hose.
With the dishwasher empty and no
detergent, place a glass with 8 ounces of
vinegar upright into the lower rack, and
then run a Normal cycle.
This is normal operation.
Ensure the dishwasher is level.
Contact a qualifi ed service technician to
remove foreign material from the pump
chamber.
Rearrange the dishes.
Clean the nozzle hole.
See pages 22 and 23.
After placing the dishes into the racks,
rotate the nozzles by hand to check
whether any of the dishes interfere with
them.
Contact a qualifi ed service technician to
remove any obstruction from the drain hose
and drain hole inside the sump. After that
check the drain pump operation.
Load your dishes as recommended.
(See page 16.)
2014-08-11 2014-08-11 6:25:47 6:25:47