Kenmore 148.16156211 Use & Care Manual page 24

Cut tie wraps holding regulator and side burner valve in place underneath grill head control panel. Be
careful not to cut igniter wires or the tie wraps holding the igniter wires in place.
With the aid of an assistant, lift and place grill head onto cart. Grill head sides go over attachment
tabs on cart. Make sure that side burner valve hangs outside the cart, and that regulator and igniter
wires hangs inside the cart. Attach head to cart with 4 screws as shown.
1/4-20 x 5/8"Screw
Qty. 4
Burner Box
Cabinet
Loosen the four screws attached to the left panel of the burner box 3 to 4 turns as shown. Hang the
side shelf by the slotted holes in its side onto the four loosened screws. Open the grill lid and use the
1/4-20 x 1-1/4" screw to fasten the side shelf from the inside of the burner box as shown. Tighten the
four previously loosened screws.
Loosen
1/4-20 x 1-1/4"Screw
Qty. 1
Side Shelf
24