Replacing The Microprocessor - Lenovo ThinkCentre 7522 User Manual

Replacing the microprocessor

Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the microprocessor.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and
wait three to five minutes to let the computer cool before opening the computer
cover.
To replace the microprocessor:
1. Open the computer cover. See "Opening the computer cover" on page 14.
2. Pivot the drive bay assembly upward to gain access to the system board. See
"Accessing the system board components and drives" on page 16.
3. Locate the heat sink and fan assembly and disconnect the heat sink and fan
assembly cable from the microprocessor fan connector on the system board.
See "Locating parts on the system board" on page 11.
4. Remove the heat sink and fan assembly. See "Replacing the heat sink and fan
assembly" on page 31.
5. Place the heat sink and fan assembly on its side so that the thermal grease
does not come in contact with anything.
6. Remove the hard disk drive. See "Replacing the hard disk drive" on page 24.
7. Lift the small handle 3 and open the retainer 1 to access the
microprocessor 2 .
Chapter 2. Installing options and replacing hardware
33