Table of Contents
Advertisement
TCD300E(e).book Page 43 Tuesday, October 12, 2004 8:22 PM
L To cancel a selected base unit
number, press the number again. The
number will stop flashing.
8
Press ,.
9
Select "Yes", then press ,.
10
Press {ih}.
Note:
L To register the handset to another base
unit or to the same base unit again, see
manual registration (page 41).
Increasing the range of the base
unit
You can increase the range of the base unit
by using a DECT repeater. Please use only
the Panasonic DECT repeater noted on
page 5. Consult your Panasonic dealer for
details.
Important:
L Before registering the repeater to this
base unit, you must turn the repeater
mode on.
Turning the repeater mode on/off
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
29).
4
Select "Other Options", then press
,.
5
Select "Repeater Mode", then press
,.
6
Select "On" or "Off", then press ,.
7
Press {ih}.
Note:
L After turning repeater mode on/off, you
will not be able to make or receive calls for
a few moments.
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Multi-unit Operation
Intercom between
handsets
Example: When handset 1 calls handset 2
1
Handset 1:
Press {INT} and {2} (desired handset
number).
2
Handset 2:
Press {C} or {s} to answer.
3
When finished talking, press {ih}.
Note:
L Intercom calls can be made between
handsets in the same radio cell, but not
between handsets in different radio cells.
Transferring calls
between handsets,
conference calls
Outside calls can be transferred between 2
handsets in the same radio cell. 2 handsets
in the same radio cell can have a conference
call with an outside party.
Example: When handset 1 transfers a call
to handset 2
1
Handset 1:
During an outside call, press {INT} and
{2} (desired handset number).
L The outside call will be put on hold.
L If there is no answer, press {INT} to
return to the outside call.
2
Handset 2:
Press {C} or {s} to answer the page.
L Handset 2 can talk with handset 1.
3
Handset 1:
To complete the call transfer, press
{ih}.
To establish a conference call, press
{3}.
43
Advertisement
Table of Contents
