Settings And Adjustment When Peripheral Equipment Is Connected; Vtr Constant Values Setting When Editor Is Connected; System Phase Adjustment - Sony BETACAM SX DNW-A30 Maintenance Manual

1-15. Settings and Adjustment when Peripheral Equipment is Connected

1-15. Settings and Adjustment when Peripheral Equipment is Connected

1-15-1. VTR Constant Values Setting when Editor is Connected

When this unit is used by connecting to an editor, set the VTR constant values of the editor depending on
the model of a player.
The VTR constant values of a connected editor
Model name
1 2
DNW-A30 B0 48
DNW-A30P B1 48
DNW-30 B0 49
DNW-30P B1 49
m
1. Set the data of No.8 of the VTR CONSTANT 1 to "0A" for the following editors.
. BVE-900 ROM version: less than or equal 1.08
. BVE-600 ROM version: less than or equal 1.01
2. In case of remote-controlling this unit by the editor, set the setup menu ITEM No.401: FUNCTION
MODE AFTER CUE-UP to "STOP".

1-15-2. System Phase Adjustment

An external reference video signal must be input to this unit after they are adjusted so that SC-H con-
forms to the specification.
When Connecting to a Digital Switcher
Fundamentally, the system phase adjustment is not necessary.
Refer to the manual of digital switcher for details.
When Connecting to a Analog Switcher
Perform the system phase adjustment referring to the manual of the analog switcher.
The system phase is adjusted by using the SYNC knob and SC knob of SYSTEM PHASE on the sub
control panel in this unit.
m
. Be sure to adjust in PB mode.
. The playback sound may be momentarily interrupted when the SYNC/SC knob is turned during tape
playback.
1-24
VTR CONSTANT1
Data No.
3 4 5 6 7
00 96 07 07 03
00 96 07 07 03
00 96 07 07 03
00 96 07 07 03
VTR CONSTANT2
Data No.
8 1 2 3 4
8A 0A 07 FB 00
8A 0A 07 FB 00
8A 0A 07 FB 00
8A 0A 07 FB 00
The value is shown in hexadecimal notation.
5 6 7 8
81 3D FF 4B
81 3D FF 4B
81 3D FF 4B
81 3D FF 4B
DNW-A30/A30P
DNW-30/30P