Advertisement
Table of Contents
Section
1.
Description ................................. 1
2.
Mounting..................................... 2
3.
Connections ............................... 2
1.
Description
The JSK-120 is a single axis joystick designed for use with our Pro-160 /
360 series controllers.
It has a hall effect sensor for long life.
It has a removable detent to identify the center off position.
It has a removable end stop to limit the travel to 120 degrees.
All parts are replaceable.
JSK-120 V1.0 05/21
Instruction Manual
JSK-120
Contents
Page Section
Page 1
4.
Calibration .................................. 2
5.
Disassembly ............................... 3
©4QD Ltd www.4qd.co.uk
Page
Advertisement
Table of Contents
Related Manuals for 4qd JSK-120
Summary of Contents for 4qd JSK-120
- Page 1 Mounting........2 Disassembly ....... 3 Connections ....... 2 Description The JSK-120 is a single axis joystick designed for use with our Pro-160 / 360 series controllers. It has a hall effect sensor for long life. It has a removable detent to identify the center off position.
- Page 2 Mounting The JSK-120 requires a 47mm diameter hole in the mounting panel. There is no limitation on the panel thickness. Connections The JSK-120 uses the Vishay 981HE sensor and the wiring colours are somewhat counter intuitive…. Green = +5V ...
- Page 3 1. Insert a 1.5 mm allen key through the collar hole into the drum grub screw. 2. Undo the M4 handle retaining screw. 3. Place the JSK-120 handle side down and lift off the collar / drum / sensor assembly. Take care to retain the ball bearing, spring and serrated washer.
- Page 4 6. Insert the sensor shaft into the drum, the wires should be at the top, nearest to the grub screw, the shaft flat should align with the grub screw. 7. Fit the sensor holding screws and then gently tighten the grub screw. JSK-120 V1.0 05/21 Page 4 ©4QD Ltd www.4qd.co.uk...
Need help?
Do you have a question about the JSK-120 and is the answer not in the manual?
Questions and answers