Operating
8.1
Operating the device on the local display
8.1.1
Display views
There are three view types:
• Operation view
The operation views are fully configurable to show different process values in different
operation view types. Depending on the operation view type configuration the view is one
of the following:
– Reading the process values (Page 46): Show the measurement values.
– Handling alarms (Page 48): Show the active alarms in a list.
– Operating the totalizer (Page 48): Enable the totalizer reset.
– Reading the diagnostic values (Page 50): Show six configurable measurement/
• Parameter view
The Parameter view (Page 50) shows the menus and parameters. The parameter view is
used to navigate through the menus and parameters in the device.
• Edit view
The Edit view can be entered from the parameter view. The edit view is used to edit the
parameters.
SITRANS FST090
Operating Instructions, 11/2021, A5E50387341-AA
diagnostic values.
8
43