Advertisement
INSTALLATION AND OPERATION MANUAL
25-PAF, 55-SHP25 AND 55-TRP25
Thank you for purchasing this product from a fine line of heating equipment.
We wish you many years of safe heating pleasure.
NOTE: IF YOU HAVE A PROBLEM WITH THIS UNIT DO NOT RETURN IT TO
THE DEALER. CONTACT CUSTOMER SERVICE @ 1-800-245-6489.
Save these Instructions.
Please Note the Following Precautionary Statements:
WE DO NOT RECOMMEND PELLET UNITS AS YOUR ONLY SOURCE OF HEAT.
England's Stove Works highly recommends the use of smoke detectors and
Carbon Monoxide detectors with any hearth product, including this unit. Follow all
manufacturer's instructions when using smoke or Carbon Monoxide detectors.
This unit is designed as an Add-On Furnace, to supplement your existing system.
It is not designed to heat your home from a cold start.
NOTE: THIS STOVE IS NOT MOBILE HOME APPROVED
CAUTION: These units must be installed in accordance with these instructions and
comply with your local building and fire codes. Please read this entire manual before
installation and use of this pellet fuel burning add-on furnace.
Keep children, furniture, fixtures and all combustibles away from any heating appliance.
WARNING: USE OF OUTSIDE AIR IS MANDATORY WITH THIS UNIT.
DO NOT OPERATE UNIT WITH HOPPER OPEN. LID MUST BE SHUT AND SECURED TIGHTLY.
DO NOT OPERATE WITH DOOR OPEN, OPEN DOOR ONLY WHEN LIGHTING.
SAFETY NOTICE
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN PROPERTY
DAMAGE, BODILY INJURY OR EVEN DEATH. FOR YOUR SAFETY AND PROTECTION,
FOLLOW ALL THE INSTALLATION INSTRUCTIONS. CONTACT YOUR LOCAL
BUILDING OR FIRE OFFICIALS FOR RESTRICTIONS AND INSTALLATION
INSPECTIONS IN YOUR AREA.
Rev. 1/2006
Advertisement
Table of Contents
Related Manuals for Warnock Hersey 25-PAF
Summary of Contents for Warnock Hersey 25-PAF
- Page 1 INSTALLATION AND OPERATION MANUAL 25-PAF, 55-SHP25 AND 55-TRP25 Thank you for purchasing this product from a fine line of heating equipment. We wish you many years of safe heating pleasure. NOTE: IF YOU HAVE A PROBLEM WITH THIS UNIT DO NOT RETURN IT TO THE DEALER.
- Page 2 A letter from our Technical Support department: Thank you for purchasing this fine product from England’s Stove Works! England's Stove Works was started, and is still owned by, a family that believes strongly in a "Do It Yourself" spirit – that’s one reason you found this product at your favorite “Do It Yourself”...
- Page 3 IMPORTANT INFORMATION 1. Check local installation codes for your area. 2. Read and comply with the instructions in this manual. 3. This unit should be tested (dry run) before loading pellets. 4. Your stove is designed to burn Premium Hardwood Pellets. Pellets with a high ash content will burn dirty and the unit will need cleaning more frequently.
-
Page 4: Flue System
Some dealers will prepare your unit for operation and even “dry run” it before delivery. If this has not been done, you can follow the steps as listed below. Attach the spring handle to the door by turning it counterclockwise. Install the hopper lid latches as illustrated by the drawing at the rear of this manual. -
Page 5: Floor And Wall Protection
A wall strap should be placed just below the last 90-degree section to make the system more stable. If you live in an area that has heavy snowfall it is recommended the installation be taller than three feet (3’) to get above the snow drift line. This same installation can be used if your stove is below ground level by simply adding the clean-out section and vertical pipe inside until ground level is reached. -
Page 6: Start-Up Procedure
Wall Protection From the rear and sides of this stove only six inches (6”) of clearance is required to paneling, wallpaper or sheet rock. The pellet vent pipe would require the standard three inches (3”) clearance as recommended by the manufacturer. Normally additional wall protection is not required with this type unit. -
Page 7: Daily Operation
room air blower will stop operating; the exhaust blower and the bottom auger will cease to operate when the temperature drops to 90 degrees. The red light will now shut off and the unit will be completely down. Keep in mind that the hotter the unit is operating, the longer it will take for the stove to complete the shut down cycle. -
Page 8: Maintenance
Weekly Ash Removal Shut the unit down by pressing the “OFF” pad and allowing the unit to go through the complete shut down cycle. Allow the unit to completely cool down and then remove the ashes by pushing them into the ash pan and dumping them. {NOTE: The 3” x 9” Ash Dump Door (the flat, rectangular piece of steel with a handle that is located directly above the ash pan) must be pulled out so the ashes from the burn pot area can be dropped into the ash pan. - Page 9 Auger Bearings and Auger Shafts The auger bearings (PART #PU-UCF204-12) are a sealed unit and do not require lubrication. To replace the top auger all the fuel must be removed from the hopper, as well as the top auger motor assembly (see above). Once this is done the four bolts that hold in the bearings can be removed.
- Page 10 THE FUNCTION OF THE ADD-ON FURNACE The Add-On Furnace is designed to be a supplemental hot air heating system that will connect to your existing heating system. The furnace will operate independently of your existing system while using the same hot air ducts that your present furnace uses. The furnace comes standard with a 850 CFM blower that pushes hot air up both sides and across the top of the unit through an inner-duct chamber built around the firebox.
- Page 11 Installation Notes Flashing 12” Min. (Use Cap) 3” Min. 3” Min. Clearance Clearance 3” Min. Outside Air Inlet: Use ” I.D. Pipe (see manual) NOTE: 1. If 3” flue pipe exceeds 15’ in length, increase to 4” flue pipe for remaining flue connections.
- Page 12 Recommended Heat Ranges: Low Burn: Heat Range setting: 1 Room Air Blower setting: 1 Medium Low: Heat Range setting: 2 – 3 Room Air Blower setting: * Medium High: Heat Range setting: 5 – 8 Room Air Blower setting: * High Burn: Heat Range setting: 9 Room Air Blower setting: 9...
-
Page 13: The Control Board
THE CONTROL BOARD The control board (PART #PU-CB98) is a digital read-out board. This board offers a wide variety of settings to operate the unit. Again, the bottom controls are preset at the factory and should not require any alteration on start-up of the unit (see “Unit Preparation” section for information on setting the Heat Range). - Page 14 Have this information on hand if you phone the factory or your dealer regarding this product. Retain for your files: Model Number __________________________ Date of Purchase ________________________ Date of Manufacture _________________ Serial #_____________________ LIMITED 5 YEAR WARRANTY FROM THE DATE OF PURCHASE TO THE ORIGINAL OWNER The manufacturer extends the following warranties: Five Year Period:...
- Page 15 ACCESSORIES and REPLACEMENT PARTS LIST FOR 25-PAF, 55-SHP25 and 55-TRP25 OPTIONS: AC-3000 3” PELLET VENT KIT AC-3001 REMOTE THERMOSTAT AC-106-P/SH-106-P BRASS WINDOW TRIM AC-103 BRASS LIP TRIM FOR ASH APRON PU-DTSTAT WALL THERMOSTAT REPLACEMENT PARTS: AC-GGK GLASS GASKET KIT AC-DGKC...
- Page 16 Pellet Stove Exploded View...
-
Page 17: Troubleshooting Guide
TROUBLE-SHOOTING GUIDE WARNING: TO AVOID ELECTRICAL SHOCK ALWAYS DISCONNECT THE UNIT FROM THE POWER SOURCE BEFORE ATTEMPTING ANY REPAIR. IF THIS GUIDE DOES NOT CORRECT THE PROBLEM CALL YOUR LOCAL DEALER OR CUSTOMER SERVICE AT 1-800-245-6489. Problem Cause Solution 1. Auger not turning 1. -
Page 19: Warranty Registration
WARRANTY REGISTRATION Purchased by (Name) ______________________________________________ Address _________________________________________________________ City ________________________ State __________ Zip _________________ Telephone _______________________________________________________ Email (Optional) ___________________________________________________ DEALER INFORMATION Purchased From (Dealer) ___________________________________________ Address _________________________________________________________ City ________________________ State __________ Zip _________________ UNIT INFORMATION Model Number _____________________ Purchase Date* _________________ Serial Number _____________________ Mfg.
Need help?
Do you have a question about the 25-PAF and is the answer not in the manual?
Questions and answers