Epson PowerLite Presenter User Manual page 62

The warning light is flashing orange and the
High-speed cooling is in process. If the projector gets too hot again, projection stops
automatically. Make sure the projector is at least 8 inches (20 cm) away from the wall.
Clean or replace the air filters if necessary (see page 54). If you are using the projector at an
altitude above 4900 feet (1500 meters), turn on High Altitude Mode (see page 51).
The warning light is flashing orange.
The lamp needs to be replaced. See page 56.
The light is red and the
The projector is too hot and has turned off the lamp. Make sure the projector is at least 8
inches (20 cm) away from the wall.
Clean or replace the air filters if necessary (see page 54). If you are using the projector at an
altitude above 4900 feet (1500 meters), turn on High Altitude Mode (see page 51).
Let the projector cool for five minutes. When the
turn the lamp back on. If the status doesn't change, wait a few minutes, then unplug the
projector and contact Epson. See page 68.
The light is red and the
The lamp may be incorrectly installed, the lamp cover may be loose, or the lamp may be
broken. Turn off the power, wait a few minutes (or wait 1 hour if you've been using the
projector), and check the lamp. See page 58. If the lamp is broken, or the lights continue to
flash after you turn the power back on, unplug the projector and contact Epson. See page 68.
The light is red and the
The projector has a problem with its fan or temperature sensor. Wait a few minutes, then
unplug the projector and contact Epson. See page 68.
The light is red and both
The projector may have an internal error. Press
again, and press
Epson. See page 68.
The light is red and both
The projector may have an auto iris or ballast error. Unplug the projector and contact Epson.
See page 68.
62
Problem Solving
warning light is red.
warning light is flashing red.
warning light is flashing red.
warning lights are flashing red.
again. If the lights continue to flash, unplug the projector and contact
warning lights are red.
light is flashing red.
light turns orange, press the button to
. Then unplug the power cable, plug it in