Electronic acid neutralizer with the lercv1 valve (16 pages)
Summary of Contents for Lancaster 7-LETCT-1
Page 1
7-LETIMG-3 7-LETDAN-2 7-LETDAN-3 Congratulations on purchasing your new Lancaster Water Filter. This unit is designed to give you many years of trouble free service. For servicing and future inspection purposes, please file this booklet with your important documents. In the event that you need assistance for servicing your water filter, please first contact the professional contractor who installed the system.
INSTALLATION Place filter in desired location close to water supply inlet, after pressure tank, and near a source for waste water, (utility sink, floor PRESSURE BYPASS SHOULD TANK drain or sewer line). A 115/120V, 60Hz uninterrupted outlet is required. BE PIPED IN IF OPTIONAL BYPASS VALVE IS NOT USED Keep filter far enough away from walls and other obstructions to allow...
PROGRAMMING THE CONTROL VALVE: Note: A quick-reference card is stored inside the front cover of the control valve. To access this card, slightly pull tabs on side of cover outward and pull cover forward. Plug the electrical cord into a 115 Volt receptacle.
ADDITIONAL PROGRAMMING INFORMATION AVAILABLE FROM LANCASTER WATER TREATMENT UPON REQUEST. INCLUDES: 7-DAY OPTION, REGENERATION CYCLES, TIMES AND 50 Hz. SERVICE INSTRUCTIONS ACID NEUTRALIZERS, (7-LETDAN-): Mineral used: Calcite. Calcite will dissolve in proportion to the amount of acid in the raw water.
DRIVE ASSEMBLY CONTINUED To inspect drive gears, the drive gear cover needs to be removed. The drive gear is held in place on the drive bracket by three clips. The largest of the three clips is always oriented to the bottom of the drive bracket. Before trying to remove the drive gear cover, the drive bracket must be removed from the drive back plate.
SPACER STACK ASSEMBLY: To access the spacer stack assembly remove the drive assembly, drive cap assembly and piston. The spacer stack as- sembly can be removed easily without tools by using your thumb and forefinger. Inspect the black o-rings and red or clear lip seals for wear or damage.
BYPASS VALVE: The working parts of the bypass valve are the rotor assemblies that are contained under the bypass valve caps. Before working on the rotor, make sure the system is depressurized. Turn the red arrow shaped handles toward the center of the bypass valve and back to the arrow direction several times to ensure rotor is turning freely.
Page 10
V3186EU WS1 AC ADAPTER 220-240V-12V EU Not Shown V3186UK WS1 AC ADAPTER 220-240V-12V UK V3186-01 WS1 AC ADAPTER CORD ONLY * Drawing number parts 2 through 6 may be purchased as a complete assembly, part V3002. FRONT COVER AND DRIVE ASSEMBLY When replacing the battery, align Correct positives and push down to fully seat.
▲ and ▼ b. Set-up error b. Check control valve set-up buttons are depressed. procedure A DIVISION OF C-B TOOL CO. 1340 MANHEIM PIKE ● LANCASTER PA 17601-3196 ● TEL:717-397-3521 ● FAX: 717-392-0266 4/15 PAGE 12 www.lancasterwatertreatment.com ● E-mail: info@lancasterpump.com...
Need help?
Do you have a question about the 7-LETCT-1 and is the answer not in the manual?
Questions and answers