Assembling The Sparkling Beverage Maker; Installing The Sodastream Co 2 Carbonator - KitchenAid KSS3121 Instructions Manual

ASSEMBLING THE SPARKLING BEVERAGE MAKER

Installing the SodaStr_eam CO
NOTE: Models include either the 60L CO
Installation instructions below show the image of the 60L CO
applicable to both carbonators.
Befor_e Fir_st Use
Place the Sparkling Beverage Maker on a
flat, sturdy surface, in an upright position.
Remove packaging materials.
The Sparkling Beverage Maker uses 3 AAA
batteries (preinstalled). To replace batteries,
see the "Care and cleaning" section.
Remove seal and cap from SodaStream
2
CO Carbonator. Insert SodaStream
2
CO Carbonator. For 60L*, first tip
2
downward into the base and then
push upward into the valve fitting.
For Mini Carbonator, push upward into
the valve fitting.
To reinstall back cover: tilt back cover
4
toward you; insert bottom tab into slot
and push cover into place.
* The 60L
SodaStream
on the level of carbonation.
8
W10790834A_EN-Final.indd 8
Car_bonator_
2
Carbonator or the Mini CO
2
Carbonator produces up to 60 liters of sparkling water, depending
Carbonator, but they are
2
To remove back cover: Grasp back
1
cover and pull away from unit. Set
cover aside.
Turn the SodaStream CO
3
counterclockwise until tight. Hand-
tighten only.
Carbonator.
2
Carbonator
2
6/8/15 4:43 PM