Problems When Projection Starts; Other Problems - Epson EMP-83 User Manual

Epson emp-83: user guide
Hide thumbs Also See for EMP-83:
Table of Contents

Advertisement

Problem Solving

Problems when projection starts

f
f
Power does not turn on
Check
Did you press the [Power] button?
Are the indicators switched off?
Do the indicators turn on and off when the power cable is
touched?
Is the operation lock set to "Full Lock"?
Is the correct setting for the remote receiver selected?
(EMP-83/822 only)
Was the power cable plugged back in immediately after
Direct Power Off, or is the breaker turned off?
(EMP-83/822 only)

Other problems

f
f
There is no audio or the audio is too low
Check
Is the audio source connected correctly?
Is the volume adjusted to the minimum setting?
Is A/V Mute active?
Is the audio cable's specification "No resistance"?
Press the [Power] button to turn the power on.
The power cable is not connected correctly or power is not being supplied normally.
Connect the projector's power cable correctly. s Quick Start Guide
Check that your electrical outlet or power source is functioning correctly.
There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power
cable. If this does not solve the problem, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the International Warranty
Terms.
sInquiries
When you press and hold down the [Enter] button on the control panel for about seven seconds, a message is
displayed and the lock is released. s
Check the "Remote Receiver" in the configuration menu. s"Settings"-"Remote receiver"
When the operation to the left is performed when "Direct Power On" is set to "On", the power may not turn
back on. Press the [Power] button to turn the power back on.
Check that the cable is connected to the Audio port.
Adjust the volume so that sound can be heard. s Quick Start Guide
Press the [A/V Mute] button on the remote control to cancel A/V Mute. s
When using a commercially available audio cable, make sure it is labelled "No resistance".
Remedy
p.20
Remedy
46
p.28
p.15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Emp-x5Powerlite s5Emp-s5Emp-822Emp-83/822Emp-x5/s5

Table of Contents