Epson Stylus Pro 4000 Start Here Manual page 4

Load Cut Sheet Paper
When you are ready to print on cut sheet paper, make sure you release the paper lever and
wind up the roll paper. Then return the paper lever to the secured position and close the roll
paper cover.
Some papers cannot be used with the paper tray. You need to load them through the front or top
Note:
manual feed slots. See the Printer Guide for details.
1
Make sure the printer is on and ready
to print.
2
Pull out the paper tray and cover,
then remove the cover. Flip up the
paper guide roller.
3
Slide the edge guide all the way to the left.
4
Thumb through a stack of paper, then gently tap
it on a flat surface to even the edges.
5
Load the sheets in the portrait
orientation, with the whiter or glossier
printable side face down. Place the paper
all the way back, against the right side of
the tray.
Don't load paper above the arrow mark
inside the edge guide.
6
Adjust the paper tray and edge guide
according to the paper size. For small
sheets, raise the paper guide and move
it to the edge of the stack.
7
Flip down the paper guide roller, then
replace the paper tray cover and adjust
its length.
Make sure the roll paper support
Note:
is not raised.
8
Press the Paper Source button until you see the cut sheet icon.
Paper guide
roller