Troubleshooting - Performance Tool W50045 Owner's Manual

ASSEMBLY
The LCD monitor in this camera unit is fixed to the body.
To assemble unit:
1. Pull back the locking collar on the receiving end of the display unit.
2. Align metal tab on threaded end of camera cable with the slot in the collar.
3. Hand tighten the collar onto the cable until secure.
The accessories included with this unit can be used to retrieve small parts, or provide
better viewing into inaccessible areas. These can be attached to the camera head using
the accessory collar as follows:
1. Slide the desired accessory through the accessory collar and align with the notch inside.
2. Position the hook on the end of the accessory behind the camera head.
3. Slide the accessory collar over the camera head with the accessory in place, until tightened.
Video Output:
The video cable included with this camera can display a live feed to any standard RCA
video input jack on a TV, monitor or other compatible device. Use the included video
cable to connect the inspection camera to your viewing device and operate the camera
normally.
TROUBLE SHOOTING
Problem:
No image .................................................
No image .................................................
No image .................................................
No image .................................................
Picture upside down ................................
No video playback ...................................
No video playback ...................................
6
Solution
Check for LED indicator light. If not on, hold the
power button down for at least 3 seconds until
light comes on.
Check for proper installation of batteries.
Replace batteries with a fresh set if necessary.
Check for any obstructions on lens of camera. If
in low light, try different light levels.
Check for proper installation of the camera cable
to body of the unit.
Press the center rotate image button until
desired view is achieved.
Check connection between video output jack
and video cord.
Ensure RCA cable is inserted into proper video
input jack.