Thomas & Betts Blackburn COMFORT CRIMP TBM41E Instructions For Use

Featuring the Color-Keyed System
®
COMPRESSION TOOL WITH SHURE STAKE
For Installing Color-Keyed
IMPORTANT:
information in this manual before operating or servicing this tool.
WARNING
KEEP ALL BODY PARTS AWAY FROM DIE NEST
DURING GAGING OR CRIMPING PROCEDURE.
In the event the SHURE STAKE
1.0
1.1
For Use With Color-Keyed
1.
Open handles fully.
2. Depress wheel release button and rotate
wheel to proper die nest. Allow wheel to lock
into position by releasing button.
3. Insert lug into the nest as shown in Figure 2.
4. Close the handles slightly to secure the
terminal. Do not deform the terminal.
5. Insert stripped wire.
6. Close handles until the SHURE STAKE
mechanism cycle has been completed.
7. Perform two equally spaced crimps on the
terminal barrel.
TA04572 D Page 1 of 2
TBM41E COMFORT CRIMP
Lugs, Splices, C-Taps and Pigtails
Read and understand all of the instructions and safety
Push to
Release
Die Wheel
Green Die
C-TAPS ONLY
Model No.
MECHANISM must be released, please see Figure 4.
®
INSTRUCTIONS FOR USE
Copper and Aluminum
®
WARNING
HANDLES ARE NON-INSULATING.
DO NOT CRIMP ON HOT ENERGIZED WIRES.
Lugs, Splices, Pigtails and C-Taps
®
®
®
MECHANISM
®
Figure 1
Figure 2