JVC RX-D302B Service Manual page 9

3.1.3 Removing the rear panel
(See Fig.5)
• Remove the top cover.
(1) From the back side of the main body, remove the strain re-
lief from the rear panel in the direction of the arrow and re-
move the power cord.
(2) Remove the twenty-nine screws F attaching the rear panel.
(3) Remove the nut and washer attaching the coaxial connec-
tor to the rear panel.
3.1.4 Removing the tuner
(See Fig.6)
• Remove the top cover.
(1) From the top side of the main body, disconnect the card
wire from the connector
(2) From the back side of the main body, remove the two
screws G attaching the tuner to the rear panel and take out
the tuner.
3.1.5 Removing the subwoofer board
(See Fig.6)
• Remove the top cover.
(1) From the top side of the main body, disconnect the wire
from the connector CN524
(2) From the back side of the main body, remove the screw H
attaching the subwoofer board to the rear panel and take
out the subwoofer board.
3.1.6 Removing the compulink board
(See Fig.6)
• Remove the top cover.
(1) From the top side of the main body, disconnect the wire
from the connector CN565
(2) From the back side of the main body, remove the screw J
attaching the compulink board to the rear panel and take
out the compulink board.
3.1.7 Removing the front video board
(See Fig.6)
• Remove the top cover.
(1) From the top side of the main body, remove the tie band
bundling the wires.
Reference:
After reassembling, bundle the wires with the new tie
band as before.
(2) Disconnect the wire from the connector
ume board
(3) From the back side of the main body, remove the two
screws K.
(4) Remove the nut and washer attaching the coaxial connec-
tor to the rear panel.
CN1 on the tuner.
on the subwoofer board.
on the compulink board.
CN662 on the vol-
Strain relief
Power cord
F
F
Fig.5
Volume board Tuner
Front video board
CN662
Tie band
Compulink board
CN565
J
Rear panel
Coaxial connector
Fig.6
Rear panel
F
Subwoofer board
CN524
Rear panel
CN1
K G H
Nut and washer
(No.MB383)1-9