DeWalt DS610 Manual

DS610 WIRELESS INDOOR MOTION SENSOR
NOTE: This product works only with the DS600
Mobilelock
GENERAL SAFETY RULES
WARNING: Read and understand all instructions and
warnings for this product.
In addition, read and follow all instructions and warnings
provided with the DS600 Mobilelock Portable Alarm System.
CAUTION: DANGER OF EXPLOSION, INJURY, OR FIRE.
Carefully follow all instructions and warnings on the battery
label and package.
•
Never use a damaged or worn out battery
•
Discharged batteries should be replaced only with type
CR-123 3.0 Volt Lithium batteries.
•
Do not use re-chargeable batteries or attempt to change
batteries.
•
Carefully remove the old, discharged battery.
•
Do not attempt to open battery.
•
Do not peel the label from the batter.
•
Never dispose of a batter in a fire.
•
Dispose of used batteries in accordance with local
regulations.
•
Recycle batteries.
•
Always insert batteries correctly with regard to polarity (+
and -) marked on the battery and the equipment.
•
When installing the battery, do not use excessive force. If
the battery does not fit, check to make sure that it
matches the polarity markings.
•
Never expose the battery terminals to any other metal
object. This can short circuit the battery.
•
Avoid exposure to temperature extremes.
•
When not in use store the battery in a cool, dark, dry
place.
•
Keep batteries out of reach of children.
FCC REGULATORY STATEMENT (FCC: X8W-BC832)
• This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) the
device must accept any interference received, including
interference that may cause undesired operation.
Components (Fig. 1)
A. Sensitivity Dial
B. Reset Button
C. Tamper
Product Function (Fig. 2)
The DS610 Indoor Motion Sensor – PIR (Passive Infrared) is a
low-current motion detector extremely sensitive to moving heat
sources. This sensor provides a 50' (15.24m) range of protection
with advanced digital scanning to recognize human movements
and size to help prevent false alarms.
D. Battery
E. Additional Alerts
F. Walk Test Button
FIG. 1
CAUTION: POTENTIAL
EQUIPMENT MALFUNCTION
OR FAILURE. Do not touch the
electronic components inside
the device, except the reset
button and battery.
FIG. 3
Mounting
Tape
NOTE: The DS610 signals an alert when motion is detected by the
sensor. Once an alert is signaled, further alerts are inhibited for 90
seconds. This feature is designed to conserve battery life. Once
activated, this device will work exclusively with the assigned
DS600 Mobilelock GPS Locator with Anti-Theft Alarm.
• The DS610 features BLE (Bluetooth Low Energy) that allows
it to connect wirelessly to and only to the DS600 Mobilelock.
Range between this sensor and the DS600 can be up to 100'
if unobstructed (line of sight).
• The DS610 features a tamper (C) that notifies the system
when the sensor cover is removed.
• The DS610 device uses a CR-123 3.0V Lithium battery (D)
for long life.
• The reset button (B) should be depressed after each time a
battery is inserted.
NOTE: Metal objects blocking radio frequency (RF)
transmission can affect the range of the sensor
FIG. 2
ft.
50
10 20 30 40 50
40
30
20
10
0
5
10
15
m 5m 10m 15m
2.1m
5m 10m 15m 20m
FIG. 4
60ft.
Top
View
20m
Side
View