Installing The Transducer On The Trolling Motor Shaft - Garmin Panoptix LiveScope LVS32 Installation Instructions Manual

Assembling the Trolling Motor Shaft Mount Hardware
With the trolling motor bracket oriented correctly
included hex wrench to attach the transducer
flat washer , and rubber washer
NOTE: You must fully tighten the mount to the transducer. The recommended torque applied to the shoulder
screw is 2.5 lb-ft. (3.4 N-m).

Installing the Transducer on the Trolling Motor Shaft

You must secure the transducer cable to the shaft or other secure location during installation. Damage to the
transducer cable wire or the cable jacket can cause transducer failure.
You should mount the transducer as far from the motor as possible.
You should use the included rubber insert on a 25 mm (1 in.) trolling motor shaft.
1 Using the included hex wrench, insert the M6 screws
transducer bracket
2 Secure the transducer cable to the motor shaft or other secure location.
3 Route the transducer cable to the installation location of the sonar module while taking these precautions.
• You should not route the cable close to electrical wires or other sources of electrical interference.
• You must route the cable so it is not pinched when the trolling motor is deployed or stowed.
4 Position the transducer to your desired angle
6
.
around the trolling motor shaft.
(Trolling Motor Shaft Orientation, page
(Trolling Motor Shaft Bracket Orientation, page
to the trolling shaft bracket
NOTICE
and attach the shaft trolling bracket
5), use the
with the shoulder screw
to the
7).
,