Avanti AV-HVLP-5S Owner's Manual & Safety Instructions page 6

Clean the Spray Gun Body and Cup IMMEDIATELY after EVERY use and when it will be idle for
more than 30 minutes. Delayed or inadequate cleaning will permanently clog the Spray Gun.
GROuNDING INSTRuCTIONS
This product must be grounded. In the event of an electrical short circuit, grounding reduces the risk
of electric shock by providing an escape wire for the electric current. This product is equipped with a
cord having a grounding wire with an appropriate grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded in accordance with all local codes and ordinances.
TO PREVENT ELECTRIC SHOCK AND DEATH FROM
INCORRECT GROuNDING WIRE CONNECTION:
Improper installation of the grounding plug is able to result in a risk of electric shock. When repair
blade terminal. The wire with insulation having an outer surface that is green with or without yellow stripes
is the grounding wire.
understood, or when in doubt as to whether the product is properly grounded. Do not modify the plug
Grounded Tools: Tools with Three Prong Plugs
This product is for use on a nominal 120-V circuit and
has a grounding plug similar to the plug illustrated in
3-Prong Plug and Outlet. Only connect the product
to an outlet having the same configuration as the
plug. Do not use an adapter with this product.
GROuNDED
OuTLET
GROuNDING
PIN
3-Prong Plug and Outlet
Page 6
NOTICE
Paint hardens quickly and permanently inside Spray Gun.
For technical questions, please call 1-888-866-5797.
1. Tools marked with "Grounding Required" have
a three wire cord and three prong grounding
plug. The plug must be connected to a properly
grounded outlet. If the tool should electrically
malfunction or break down, grounding provides
a low resistance path to carry electricity away
from the user, reducing the risk of electric shock.
(See 3-Prong Plug and Outlet.)
2. The grounding prong in the plug is connected
through the green wire inside the cord to the
grounding system in the tool. The green wire
in the cord must be the only wire connected to
the tool's grounding system and must never
be attached to an electrically "live" terminal.
(See 3-Prong Plug and Outlet.)
3. The tool must be plugged into an appropriate outlet,
properly installed and grounded in accordance
with all codes and ordinances. The plug and outlet
should look like those in the preceding illustration.
(See 3-Prong Plug and Outlet.)
Item 58479 58149