Platform Overload System - Terex S8015-12264 Service And Repair Manual

Service and Repair Manual
Platform Components
5 Open the bottom bleed screw on the rotator,
but do not remove it.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
6 Move the function enable toggle switch to
either side and hold the platform rotate toggle
switch to the right position until the platform is
fully rotated to the right. Continue holding the
toggle switch until air stops coming out of the
bleed screw. Close the bleed screw.
Crushing hazard. Keep clear of
the platform during rotation.
7 Clean up any hydraulic oil that may have
spilled.
8 Rotate the platform fully in both directions and
inspect the bleed screws for leaks.
28
2-4
Platform Overload System (if
equipped)
How to Calibrate the Platform
Overload System (if equipped)
Proper calibration of the platform overload system
is essential to safe machine operation. Continued
use of an improperly calibrated platform overload
system could result in the system failing to sense
an overloaded platform. The stability of the
machine is compromised and it could tip over.
Note: Perform this procedure with the machine on
a firm, level surface.
1 Turn the key switch to platform controls. Start
the engine and level the platform.
2 Determine the maximum platform capacity.
Refer to the machine serial plate.
3 Remove all weight, tools, accessories and
equipment from the platform.
Note: Failure to remove all weight, tools,
accessories and equipment from the platform will
result in an incorrect calibration.
4 Using a suitable lifting device, place an
appropriate test weight equal to that of the
maximum platform capacity at the center of
the platform floor.
S®-80 • S®-85 • S®-80X
March 2018
Part No. 1269074GT