Warmlite WL45036 Instruction Manual page 9

USING YOUR APPLIANCE:
MANUAL OPERATION:
Make sure the ON/OFF switch, located on the
right side panel, is in the OFF position. Plug the
power cord into a 220~240 grounded outlet
(see IMPORTANT SAFETY INFORMATION
section). Make sure the outlet is in good
condition and that the plug is not loose. NEVER
exceed the maximum amperage for the circuit.
DO NOT plug other appliances into the same
circuit.
BUTTON
NOTE:
FUNCTION
ON: Enables control panel
functions and remote
control.
OFF: Disables control
panel functions and remote
control.
HEATER button: Turns
heater on and off.
NOTE: The heater only
works when the flame effect
is on. If the flame effect is
off, the heater will not turn
on.
NOTE: Heating at 2kw
only works when the 1kw
heat setting is active
NOTE: To prevent overheat-
ing, the heater blows cool
air for 10 seconds before
the heater turns on, and
after it turns off.
When the heater is first turned on, a slight odour may be
present.
This is normal and should not occur again unless the
heater is not used for a long period of time.
Power ON/OFF
Heater - Power 1
Heater - Power 2
ACTION & INDICATION
ON: Turns the flame on
at its brightest setting. All
functions are on standby,
and the flame on
OFF. Flame effect turns off.
Power and all functions
turn off.
Press once. The
Blue indicator will light
up. Heating at 1kw will
commence.
Press once. The
Blue indicator will light
up. Heating at 2kw will
commence.
Press twice. Heating at
2kw turns off.
Press twice. All heating
turns off. The Heater blows
cool air for 10 seconds then
turns off.
www.warmlite.co
9