Table of Contents
Advertisement
Problem
Unsatisfactory
washing result.
You can't see water in the
drum during washing.
The laundry has detergent
residue after washing.
Grey spots appear on the
laundry.
Spinning operation is not
performed or runs late.
26
Kenwood 7kg Washing Machine K714WM18 Manual.indd 26
Possible Causes
Your laundry is too soiled for
the wash programme you
have chosen.
Amount of detergent
used is insufficient.
You're machine is
overloaded.
The water in your area may
be very hard.
You may not have loaded
your laundry evenly.
No fault. Water is in the
unseen part of the drum.
Non-dissolving particles of
some detergents may stick
to your laundry and show as
white spots.
The reason for such spots
may be oil, cream or
ointment.
No fault. Unbalanced load
control system has been
activated.
Remedy
Choose a programme that is
suitable.
Adjust the amount of detergent
based on the amount the
laundry is soiled.
Check your detergent
instructions, make sure you are
adding the correct amount for
the weight of your load.
Load the correct weight of
laundry. Check the programme
table. Not all programmes allow
7kgs of laundry.
Check the detergent guidelines,
you may need to increase the
amount of detergent used.
Load your laundry correctly.
-
Perform an extra rinse by
setting your machine to "Rinse"
programme, or clean the spots
using a brush after your laundry
is dry.
Apply the maximum amount
of detergent instructed by the
detergent manufacturer in the
next washing operation.
Unbalanced load control
system will try to spread your
laundry by tumbling for a while.
Spinning operation will begin
after your laundry is spread.
Place the laundry in the
machine in a balanced fashion
the next time.
21/06/2018 08:10
Advertisement
Table of Contents
