Advertisement
4. CONTENTS
Item
Description (quick reference)
1
Upper handle sub assembly
2
Lower handle frame c/w hex nuts and screws
3
Handle clamp c/w carriage bolt
4
Cable clip
5
Cutter deck c/w motor, wheels and blade
6
Grass box
7
Recoil stop and cord guide
8
Recoil cord handle
9
Side discharge cover
10
Spark plug spanner (not shown)
5. ASSEMBLY
5.1.
Check that you have all the above details in the packaging.
5.2.
Assembly:-
5.2.1. Offer the lower handle frame (item 2) onto the rear wing brackets of the cutter rear deck and over the the domed head studs, see
fig.2.
5.2.2. Clamp the assembly with the knob plain washer and "c" washer.
5.2.3. Fit the upper handle sub assembly (item 1) containing the safety, clutch and throttle cable to the lower handle (item 2) paying special
attention to the cable run. Clamp the frame with the details shown in fig.3.
5.2.4. Position the cable clip (item 4) just below the frame clamp, see fig.1.
5.2.5
Attach grass box if required (item 6) with the grass box slots. Lift the spring loaded hinged panel and locate slots with tabs, see fig.4.
NOTE: The blade must be fitted observing the stamped arrow, fig.6. The retaining bolt has a standard RH thread.
WARNING! Never use blades other than the spares supplied by your Sealey Dealer.
fig.2.
Blade fitting:-
5.3.
5.3.1
Decide on the grass cutting length required, a choice of 8 are available, from 20mm to 70mm approximate grass length settings. In
fig.5 a lever adjusts mower cutting height. Pull the lever crank from the notch and sweep the lever to desired height notch.
5.3.2
To remove the blade, hold the blade with a gloved hand and undo the centre bolt with a 14mm spanner, see fig.6.
WARNING If fuel remains in the tank, tilting of the mower may cause fuel leaks.
5.3.3. To refit or change the blade, hold the blade in a gloved hand and tighten the centre bolt (30Nm).
NOTE: The blade must be fitted observing the stamped arrow, fig.6. The retaining screw has a standard RH thread.
WARNING! Never use blades other than the spares supplied by your Sealey Dealer.
fig.4.
Hook grassbox
frame over tabs
Lift stone guard hinged panel to fit grass box.
© Jack Sealey Limited
Qty
1
1
2
1
1
1
1
1
1
1
fig.3.
Stone
guard
Original Language Version
Cutter setting lever
fig.5.
Adjust cutter height
GL112
Issue No: 1 -15/04/15
Advertisement
