STREET WISE Sting Ring Instructions

DIAGRAM

1. Contact Probes
2. Stun Warning Light
3. Squeeze-N-Stun Button
4. Safety Switch
5. Charging Port

CHARGING THE BATTERIES

1.
The rechargeable batteries are already installed. The unit cannot be opened, as this will void
the warranty.
2.
Before use the stun gun will need to be charged. Connect the charging cord to the charging port (5)
and the other end into the USB port on your computer, your block charger for an electrical outlet or
your USB car charger. There are no charging indicator lights on the unit. Simply keep it plugged in
for two to three hours.
3.
IMPORTANT: Do not charge for more than 3 hours at a time. Overcharging can damage the unit
and void the warranty. Under normal use the unit will need to be recharged every 60 days. If it is
used frequently or if the electrical charge produced by the stun gun becomes noticeably weaker,
the unit will need to be recharged.

TESTING THE STUN GUN

(WARNING: Do not test fire the stun gun for more than 1 second as this will damage the unit and
void the warranty.)
1. Slide the ring over your middle finger, which will position the base of the unit in the palm of your
hand.
2. Slide the Safety Switch (4), located on the side of the unit up to turn off the safety. The Stun Warning
Light (2) on the front of the unit will illuminate.
3. Close your hand tightly around the base of the unit to press the Squeeze-N-Stun Button (3) located
on the bottom of the unit to test the stun gun. You will both see and hear an electrical charge fire
across the top of the unit between the Contact Probes (1). When test firing the unit, do not hold the
button down for more than 1 second.
4. When testing is complete, slide the Safety Switch (4) down to turn the safety back on. The Stun
Warning Light (2) will turn off.
Sting Ring Instructions
2
1
3
4
5
Rev 9/3/2019