Removing And Installing Parts Of Esp System; Removing And Installing Brake Light Switch - Audi A6 2005 Workshop Manual

Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
6 Removing and installing parts of ESP
system
6.1 Removing and installing brake light
switch
Note
The brake light switch must be removed in order to adjust it.
♦
To ensure a secure fit and reliable adjustment, the brake light
♦
switch may only be installed once.
Removing
– Remove driver's storage compartment ⇒ Rep. gr. 68 .
– Unplug electrical connector.
– Turn brake light switch anti-clockwise through 45° and re‐
move.
Installing
Install in reverse sequence, paying attention to the following:
– Pull out plunger of brake light switch as far as it will go
-arrow-.
Note
On some types it is not necessary to pull out the plunger prior to
installation. The method of installation is the same.
– Fit retainer tabs -1- and -2- on switch into recesses in mounting
hole.
Note
When installing, brake pedal must not be pressed.
♦
The plunger adjusts itself automatically when the brake light
♦
switch is inserted.
50
Rep. gr.45 - Anti-lock brake system