KT RECOVERY+ WAVE Quick Start Manual

wave
RECOVERY
ELECTROMAGNETIC PAIN RELIEF
1. BEFORE YOU START
APPLY BEFORE ACTIVITY
Apply tape one hour before
beginning activity.
END ON SKIN, NOT ON TAPE
Apply directly to skin when possible,
especially the ends.
ADHESIVE TAPE
WARNING: For external use only. Do not use this product if you have poor circulation, or are diabetic. Do not use if you are allergic to any component of this
product. Do not apply to any infected areas. Only apply each strip one time. Discontinue use if skin becomes irritated. Do not use product if paper backing has
been damaged or removed. This product is not made with natural rubber latex.
READ ALL CAUTIONS AND INSTRUCTIONS PRIOR TO USE. ©2020 KT Health, LLC, American Fork, UT 84003. All rights reserved.
NOTE: Store away from sunlight in a dry, cool environment between 40°- 80°F . Questions? Email us at
2. HANDLING TAPE
To apply strips without touching adhesive:
APPLY MIDDLE FIRST
Open
Open backing paper
at center perforation.
3. HOW TO TURN DEVICE ON & OFF
How to turn the Device On:
Step 1: To activate the device, remove
the white tab from the back of the
device and push the silver on/off button
for 1-2 seconds. Release the button.
*Throw away white tab.
4. COMMON APPLICATION SITES
BASE OF NECK
Locate your point of pain at the base of
the neck and center the KT Wave™ over
it. Use 2-3 adhesive strips to secure the
loop to your skin.
.
UPPER BACK
Locate your point of pain and center the
KT Wave™ over it. Use 2-3 adhesive
strips to secure the loop to your skin.
Peel
Peel backing paper
slightly on each side
for easy handling.
Step 2: How to turn the Device Off:
Once the device is activated,
the green LED light on the front of the To deactivate the device, press the
device will turn on. If the green LED silver button and hold it down for 1-2
light does not turn on, please repeat seconds. Once the device is
Step 1. deactivated, the green LED light will
turn off.
SHOULDER HAND
Place the KT Wave™ on your shoulder, Place the KT Wave™ on the back of your
centering the loop over your point of hand, centering your point of pain
pain. Secure the loop to your skin on within the loop. Use 2-3 adhesive strips
both sides using the adhesive strips. to secure the loop to the forearm and
Placement may vary. back of the hand.
LOWER BACK KNEE
Sitting with your knee bent, place the
Locate your point of pain and center the
KT Wave™ over it. Use 2-3 adhesive KT Wave™ over the joint with your pain
strips to secure the loop to your skin. point in the center. Use 2-3 adhesive
strips to secure the loop in place.
*Can also be worn under clothing.
™
CLEAN SKIN
Clean dirt, oils and lotions from
area with rubbing alcohol
DON'T RIP OFF!
Gently remove tape from skin, use
baby oil if necessary and remove slowly.
Apply
Apply as shown over
loop wire.
Therapeutic area
is inside loop.
Green light illuminates
when device is turned on.
ELBOW
With your elbow bent, place the KT
Wave™ over the outside of the joint
with your pain point in the center. Use
2-3 adhesive strips to secure the loop in
place on the upper and lower arms.
BACK OF KNEE
Locate your point of pain and center the
KT Wave™ over it. Use 2-3 adhesive
strips to secure the loop to your skin.
Avoid placing adhesive strips directly
over the back of the knee.
TRIM HAIR
Trim excessive hair for better adhesion.
WATCH VIDEOS FOR HELPFUL TIPS
Visit kttape.com/instructions to view our full
database of easy-to-follow product tutorials.
support@kttape.com
Place
Center KT Wave™ over
pain point and secure
it with adhesive strips.
HIP
Locate your point of pain and center the
KT Wave™ over it. Use 2-3 adhesive
strips to secure the loop to your skin.
*Can also be worn under clothing.
FOOT
Locate your point of pain and center the
KT Wave™ over it. Use 2-3 adhesive
strips to secure the loop to your skin. .
Avoid placing the device module under
the sole of your foot. May also be worn
over foot.
The electronics and
battery are in this module.
On/off button
on back of device