Epson S1D13513 User Manual page 11

JP10
JP1
JP8
S5U13513P00C100 Evaluation Board
Rev. 1.2
JP1-JP10 - Power Supplies for the S1D13513
JP1-JP10 can be used to measure current consumption of each S1D13513 power supply.
When the jumper is at position 1-2, normal operation is selected.
When no jumper is installed, the current consumption for each power supply can be
measured by connecting an ammeter to pin 1 and 2 of the jumper.
The jumper associated to each power supply is as follows:
JP1 for COREVDD
JP2 for PLLVDD1
JP3 for PLLVDD2
JP4 for OSCVDD1
JP5 for OSCVDD2
JP6 for HVDD1 (Host interface)
JP7 for HVDD2 (LCD Panel interface)
JP8 for HVDD3 (Camera2 interface)
JP9 for HVDD4 (Camera1 interface)
JP10 for HVDD5 (SDRAM interface)
Figure 3-2: Configuration Jumper Locations (JP1-JP10)
Seiko Epson Corporation
Installation and Configuration
JP9
JP7
JP6
JP4
JP5
JP2
JP3
11