Yamaha SRS10ML53 Owner's Manual page 39

Table of Contents

Advertisement

Checking Track Tension
WARNING
DO NOT attempt to check or adjust
track tension with engine running.
Turn ignition key to the OFF posi-
tion. Personal injury could result
from contact with a rotating track.
1. Remove excess ice and snow buildup
from the track, track drive sprockets,
and the inside of the skid frame.
2. Elevate the snowmobile on a
shielded safety stand high enough to
use a spring scale.
3. At the mid-point of the track (on the
bottom side), hook a spring scale
around a track clip; then pull down
on the scale to 9 kg (20 lb). Measure
the deflection (distance) between the
bottom of the wear strip and the
inside surface of the track clip. Mea-
surement should be 50 mm (2.0 in.).
Deflection
NOTE: Measurement is from the
bottom of the wear strip at the
point of the shock pad on the slide
rail.
NOTE: Only tighten track until the
track does not ratchet. Too tight of
a track will cause the rear suspen-
sion to not work properly.
Adjusting Track Tension
NOTE: To ensure proper track
tension adjustment, perform all
adjustments on both sides of the
snowmobile.
1. Loosen the idler wheel axle cap
screws.
Track Adjuster
Adjusting Bolt
Track Adjuster
Adjusting Bolt
Track Adjuster
Adjusting Bolts
Tension
2. If the deflection (distance between
746-788A
3. If the distance between the bottom of
Always
within recommended specification.
4. Check track alignment.
5. After
146"
the bottom of the wear strip and the
inside surface of the track clip)
exceeds specifications, tighten the
adjusting bolts to take up excessive
slack in the track.
the wear strip and the inside surface
of the track clip is less than specified,
loosen the adjusting bolts to increase
the slack in the track.
CAUTION
maintain
proper
track
obtained, tighten the idler wheel axle
cap screws to 4.7 kg-m (34 ft-lb);
then tighten the adjusting bolts
securely against the axle.
Rear Idler
Wheels
Axle Cap
Screw
0745-811
Rear Idler
Wheels
Axle Cap
Screw
0750-086
Rear Idler
Wheels
Axle Cap
Screw
0748-441
track
tension
tension
is
34

Advertisement

Table of Contents
loading

Table of Contents