Adaptec 5325301656 Administrator's Manual page 71

Configure the new drive as part of the RAID.
2
When you remove a drive from a Snap Server, the affected RAID transitions to
degraded mode. It remains in degraded mode until the newly inserted drive is
configured as a member of the RAID via the Administration Tool. For details on
this procedure, see "Adding Disk Drives to a RAID" on page 56.
Replacing a Disk Drive on a Snap Server 410
Remove the front bezel by pressing in the latches on each side of the bezel and
1
pulling the bezel away from the chassis.
On the closed handle of the failed disk drive, insert your finger into the handle
2
slot and pull out to open the handle.
Pull to remove the drive from the chassis.
3
Open the handle of the new drive. If the handle is closed, you cannot insert the
4
disk drive completely into the bay.
Insert the new disk drive, making sure you push it forward until it is firmly
5
seated and the handle begins to swing closed. Then close the handle until it clicks
into place to completely seat the drive to its connection.
Replace the front bezel.
6
Chapter 4 Storage Configuration and Expansion
Disks and Units
57