Overview; Parts List; Led Indicators And Keypad Sounds - SECO-LARM SLI ENFORCER SK-1131-SPQ Manual

ENFORCER Access Control Keypad with Proximity Card Reader

Overview:

45/8 "
45/8"
(117mm)
(117mm)

LED Indicators and Keypad Sounds:

LED Indicators
Steady Available for free connection
Flashing
Keypad Sounds and LEDs
Status
In programming mode
Successful key entry
Successful code/card entry
Unsuccessful code/card entry
Power up delay
Output relay activation
In standby mode
(3)
System restore mode
Card/code already stored
Real-time clock stopped after
power loss
NOTE:
1. Keypad sounds can be programmed ON or OFF (see page 25).
2. Output relay activation sounds can be programmed for 1-sec long beep, 2 short beeps, or OFF
(see page 25).
3. Green center LED flashing during standby mode can be programmed ON or OFF
(see page 26).
6
27/8"
27/8 " (73mm)
(73mm)
Red LED (Left)
–
(2)
11/2"
11/2 "
(38mm)
(38mm)
Green/Red/Amber LED (Center)
Programming mode (green)
Output #1 inhibited (red)
Standby mode (green)
Inhibit mode paused (red/amber)
Keypad Locked (red/amber)
Sounds
(1)
–
1 Beep
2 Beeps
5 Beeps
Continuous beeping
1-Sec long beep
–
2 Beeps
1 Long beep
Continuous 3 fast beeps
every 5 seconds

Parts List:

1x Keypad
1x Back box
2x Installation screws
2x Mounting screws
1x Diode
1x Manual
Green LED (Right)
Available for free connection
–
Green/Red/Amber LED (Center)
Steady ON
1 Flash
2 Flashes
5 Flashes
Continuous flashing
–
1 Flash/sec
Fast flashing for 2.5 min
–
–
SECO-LARM U.S.A., Inc.