Page 5
1. Input Equalizer control: 3-band equalizer that adjusts high, mid, and low frequencies. High: 12KHz ±15dB Mid: 2.5KHz ±15dB Bass: 80Hz ±15dB 2. Monitor control: controls the amount of signal sent to the MONITOR bus. 3. Effect control: controls the amount of signal sent to the EFFECT bus. 4.
Page 6
22. Foot Switch input: connect a foot switch via this 1/4" jack to BYPASS or ENGAGE the built-in effects. 23. FX out: sends a stereo line level signal to an external effects processor. This signal can be RETURNED on any other LINE INPUT on the RPM109.
USB/SD Operation Inserting a USB flash drive or an SD card into the corresponding port/slot will set the RPM109 to USB/SD mode and it will automatically begin to play music. Please note: The RPM109 will not recognize USB drives formatted in the NTFS format. Drives must be formatted in the FAT or FAT32 formats.
Troubleshooting PROBLEM SOLUTION No power 1. Make sure the unit is plugged in and the power switch is in the ON position. 2. Check that the power cable is plugged in tightly to the unit. 3. Check and replace the fuse if necessary. See fuse replacement diagram on the next page. No sound 1.
Fuse Replacement Use a screwdriver to release the fuse holder. Remove the fuse holder. Remove the fuse. Replace the fuse. Re-insert the fuse holder.
Page 11
Inwood, NY 11096 Hereby declares that the product RPM109 12 channel powered mixer complies with FCC rules as mentioned in the following paragraph: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the RPM109 and is the answer not in the manual?
Questions and answers