Gecko SL20A Instruction Manual

OPERATION AND MAINTENANCE
Location and use
The Insect Killer is best located away from human activity and hung at a
height of around 2.5 metres. It is recommended that the appliance be
used continuously when people and pets are present. Ensure the unit is
placed away from other light sources. Keep away from the reach of small
children or hang using the attached hanging harness. Connect the plug
to a suitable power supply, corresponding to that of the appliance,
230VAC, 50/60Hz. For hanging use, an extension cord may be necessary.
This appliance is weatherproof and can be left outdoors.
Auto On-Off
Your appliance is fitted with Power Saving Technology. This allows the unit to
automitically swith on at dusk and off at dawn. This feature can save you power and
extends the life of the lamp.
Auto on-off. Push the slide switch back to expose the light sensor.
Full-time on. Push the slide switch forward, to cover the light sensor.
To ensure the sensor works effectively, allow at least 30cm between the top of the
unit and ceiling or eaves. Optionally wall mount the unit with the included hardware.
Insect Disposal and General Maintenance
Regular Maintenance of your appliance will keep it safe and in proper working order
1. Before Cleaning and maintenance
When not in use or before cleaning, always disconnect the appliance from the mains supply
2. Cleaning
Remove bottom tray by sliding outwards and dead insects from the appliance.
If needed, use supplied cleaning brush. As the high voltage grid is a vertical
design, it should require minimal cleaning. Do not use metal objects or stick
fingers through outer casing.
Regularly clean the outside of the appliance with a soft damp cloth and
dry it with a dry towel. Do not imerse in water. Do not use harsh solvents
to clean the plastic.
3. Ventilation
Always allow adequate ventilation for the appliance.
Failure to do so may result in overheating.
4. Damage check
Always check the appliance is in good working condition and all guards are secure.
Check the power supply cord and plug regularly for damage.
5. Lamp Replacement
IMPORTANT: Before replacing the lamp, unplug unit from mains power
and wait one minute.
1. Open lamp flap on side of unit
2. Gently remove and replace the lamp using lamp SL20G (Figure 3)
3. Close lamp flap.
Insect Killer
I N S T R U C T I O N M A N U A L
Insect Killer
MODEL: SL20A
Auto on-off
Light sensor
This appliance is weatherproof and can be
left outdoors.
READ AND SAVE THESE INSTRUCTION
Carefully read this manual before using the Gecko Insect Killer. Make sure that you know how to
operate the appliance. Maintain the appliance in accordance with the instructions to ensure that it
functions properly. If the appliance is to be used by a third party, this instruction manual must be
supplied. No liability can be accepted for any damage caused by non-compliance with these
instructions or any other improper use or mishandling.
Mayo Hardware Pty Ltd
AUST: 1300 360 211
AUST: 1300 360 484
www.geckoinsectkillers.com.au
4 Secombe Place, Moorebank, NSW, 2071
2015©