Replacing The Saw Axis Bearings; Blade Shaft/Gear - Husqvarna FS 5000D Workshop Manual

FRONT- / REAR AXLE / LIFT CYLINDER
1
2
1
3
2
Replacing the Saw Axis
Bearings
First see Changing the Blade
Shaft (p. 78) and Changing the
Pulleys (p. 65).
1� Remove the four screws holding
the bearings�
2� Remove the bearings�
3� Use a presser from the opposite
side from the proximity sensor�

Blade Shaft/Gear

First see Replacing the Saw Axis
Bearings (p. 79).
1� Press the bottom bearing out with
a bearing puller, a slide hammer
or use a pipe� Slide the pipe into
the tube from the opposite side
of where the bearings are located�
Start with removing the left
bearing�
2� Put it in a presser and gently press
it out�
Be careful and make sure not to
damage the shaft when removing
bearings.
14.7
79