Throttle Trigger And Throttle Trigger Lockout - Husqvarna K770 SmartGuard Workshop Manual

6.15.3 To assemble the wet system
1. Put the spray nozzles on to the blade guard.
2. To put the filter in the connector, push it in on a flat
surface.
3. Close the hose clip with a pair of pliers.
1453 - 001 - 02.04.2020

6.16 Throttle trigger and throttle trigger lockout

6.16.1 To remove the throttle trigger and throttle
trigger lockout
When you remove the throttle trigger lockout, use a V-
jaw adjustable pliers. Make sure that you hold the V-jaw
of the pliers adjacent to the handle. Put a cloth on the
throttle trigger lockout before you apply the pliers to
prevent damage to the surface.
1. Remove the carburetor. Refer to
carburetor on page 19 .
2. Push in the lower part of the throttle trigger lockout
with a V-jaw adjustable pliers.
3. Lift the lower part of the throttle trigger lockout and
pull it out from the pin.
To remove the
Repair and servicing - 67