Related Manuals for Challenger SLFLF15BP
Summary of Contents for Challenger SLFLF15BP
- Page 1 High Lumen LED PIR Floodlights 15w, 30w, 50w Models: SLFLF15BP, SLFLF30BP, SLFLF50BP SLFLF15BP SLFLF30BP SLFLF50BP Installation Manual...
- Page 2 Introduction Thank you for purchasing your Challenger high lumen led floodlight, these instructions should be read carefully and retained for further reference and maintenance.
- Page 3 IMPORTANT • Installation must be carried out by a skilled electrician who is familiar with the appropriate standards and technical requirements of the appliance also taking in to consideration the latest building regulations. • The person carrying out the installation is to check and verify that the total load on the circuit, including the rating of the cable, fuse and/or circuit breaker is not exceeded.
- Page 4 Specification • High lumen output LED floodlights • Slimline lightweight design • 120° PIR with up to 10m detection distance • Installation Height 2.0-2.8m • Adjustable lux setting 3-1000lux • Adjustable time delay up to 12 minutes • Manual override (OFF/ON, OFF/ON), light on for 5 hours •...
- Page 5 Specification Model Lumens Wattage Dimensions Input Weight (mm) Current SLFLF15BP 1950 148x128x45 0.2A 0.58Kg SLFLF30BP 3900, 30w, 216x190x50 0.37A 1.23Kg 2600, 20w, 1950, 15w, 1300 SLFLF50BP 6500, 50w, 247x238x52 0.72A 1.62Kg 3900, 30w, 2600, 20w, 1950 PIR Function • Time adjustment: Time can be adjusted between 8(±5) seconds and 12(±2) minutes.
- Page 6 • Sensitivity adjustment: Detection range can be adjusted between 5m & 10m approximately (this will be dependent on external factors such as mounting height, angle & background temperature). If adjusted to “-“ position, detection range will be approximately 5m, if adjusted to “+” position, detection range will be up to 10m.
- Page 7 Top view – detection angle Side view – detection distance Installation • Ensure the electrical AC power is switched OFF before and during installation • For the AC supply cable and connections, a cable that is rated to 90°C should be used •...
- Page 8 • When adjusting the angle of the fitting please ensure that there is enough slack in the cable so the range of movement of the luminaire is unhindered • Ensure that the correct wattage output has been selected (30w & 50w models only) as this will have an impact on the lighting design to ensure the correct light levels are achieved.
- Page 9 Refer to the following diagram when you install the fixture. SLFLF15BP SLFLF30BP SLFLF50BP 1. Turn off the AC Supply Fix the luminaire bracket to the surface. 2. Keep enough slack in cable to ensure when adjusting the angle, the movement is unhindered 3.
- Page 10 5. Ensure that the correct wattage output has been selected (30w & 50w models only) as this will have an impact on the lighting design to ensure the correct light levels are achieved. Please Note: The cable must be connected either through a waterproof connector or junction box.
- Page 11 IEE wiring regulations. If the defective product is no longer available, then Challenger may provide alternatives of similar specification and quality. The ambient temperatures and environment and voltage range...
- Page 12 Due to our policy of continuous improvement we reserve the right to change specification without prior notice. Errors and omissions excepted. These instructions have been carefully checked prior to publication. However, no responsibility can be accepted by Challenger for any misinterpretation of these instructions.
Need help?
Do you have a question about the SLFLF15BP and is the answer not in the manual?
Questions and answers