CORDLESS FLOOR AND CARPET SWEEPER. with brush roll blocked; keep free of fiber, lint, hair ® and anything that may prevent the brush roll from WHEN USING YOUR SHARK CORDLESS FLOOR AND working. CARPET SWEEPER, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE...
Page 3
TO MAXIMIZE THE LIFE OF YOUR Warning: Changes or modifications to this unit NI-MH BATTERIES: not expressly approved by the party responsible for Charge for 7 hours before initial use. Failure compliance could void the user’s authority to operate to do so will reduce the product’s battery life the equipment.
QUICK START IMPORTANT: Before you can start using your new cordless floor and carpet sweeper, charge it for 7 hours. NOTE: The charging adapter will be shipped inside the packaging. Fig. 2 Fig. 3 Fig. 1 ASSEMBLE CLEAN 3 Using your foot, press the 1 Insert the smaller end of the 2 Pull back on the handle and power button and push the unit...
Page 5
Fig. 5 Fig. 4 EMPTY 5 Empty dust container contents. NOTE: Be careful not to 4 When you’re finished cleaning, (Fig. 5) If desired, you may accidentally turn the unit on. pull the dust container straight rinse with water to clean out from the side.
Page 6
(Fig. 2) H Charging Adapter IMPORTANT: Charge the batteries for 7 hours before Model Number: V2700Z 32 using the unit for the first time. Voltage: 4.8 V See page 7 for instructions on charging your unit.
Page 7
CHARGING YOUR CORDLESS FLOOR AND CARPET SWEEPER Fig. 3 Fig. 4 IMPORTANT: Although many 1 Always make sure that the unit 3 Charge the battery for 7 hours is turned off. (Fig. 3) adapters look similar, it’s before initial use and 7 hours important to use only the for each recharge.
EMPTYING THE DUST CONTAINER Fig. 6 Fig. 7 Fig. 8 1 To achieve the best 2 Empty dust container contents. 3 Re-insert the dust container into (Fig. 7) If desired, you may rinse the unit. (Fig. 8) performance, empty the dust with water to clean the dust container after each use.
MAINTENANCE Fig. 11 Fig. 9 Fig. 12 Fig. 10 4 Use a coin to remove the trap 5 Connect the wire terminal from CAUTION: Do not clean the unit door if you need to remove the the unit to the wire terminal while it is charging.
TROUBLESHOOTING GUIDE PROBLEM POSSIBLE REASONS AND SUGGESTED SOLUTION The unit will not operate Batteries need to be recharged. Batteries are dead and need to be replaced. There is no power in the electrical outlet supplying the charging adapter. Try to charge using a different outlet. Ensure the wire terminal connectors on the battery pack are securely attached.
“ATTENTION CUSTOMER SERVICE”. We are constantly striving to improve our products, therefore the specifications contained herein are subject to change without notice. PRODUCT REGISTRATION Please visit www.sharkclean.com or call 1-800-798-7398 to register your new Shark product within ten (10) ®...
Need help?
Do you have a question about the V2700Z and is the answer not in the manual?
Questions and answers