Cleaning The 'P' Pod 5 - SOS P POD User Manual

3.1 CLEANING THE 'P' POD SEAT
•
use the 'P' Pod seat will require cleaning.
During
•
Seat Pod cover can be easily removed by stretching off the pod and passing the
The
pelvic band through the slots. With the Seat Pod cover removed the inside surface
of the Seat Pod can be easily cleaned using mild detergents. The Seat Pod is
manufactured from closed cell foam and is inherently waterproof.
•
the Seat Pod remains slightly damp after cleaning simply leave for a short period at
If
room temperature to dry.
•
DO NOT PUT THE SEAT NEXT TO A HOT FIRE OR USE EXCESSIVE HEAT TO
DRY AS THE SEAT POD IS THERMOPLASTIC AND COULD BE DAMAGED BY
EXCESSIVE HEAT THAT COULD AFFECT THE SHAPE OF THE SEAT.
•
DO NOT USE SCOURERS OR CAUSTIC SUBSTANCES SUCH AS BLEACH TO
CLEAN ANY PART OF THE P POD.
3.2 CLEANING THE COVERS
•
cleaning of removable covers please refer to wash label on the inside of the
For
padded covers.
•
T o remove the Seat Pod Cover simply stretch off
the Seat.
•
laundering the Seat Pod Cover, fold back
Before
the velcro retaining pads (Fig.3.2a) to prevent
them from damaging the cover material.
•
remove the Flip Over Headrest Cover: unzip
To
the cover and remove the inner foam. DO NOT
try and wash the inner foam as it is sealed in
a special membrane that cannot be removed
under any circumstances, to clean the foam
simply wipe down the plastic membrane.
•
the Bolster, Pod and Foot Support: unzip the
For
cover and remove the bag of polystyrene balls
(Fig.3.2b).
•
Whe n placing the cover back on the Seat
Pod after cleaning note that the inner label is
positioned at the top of the seat to ensure correct
alignment of the straps and general fit into the
Seat.
•
ANY DEVIATIONS FROM THE ABOVE MAY
AFFECT THE FIRE RETARDANCY OF THE
COVER(S).
Fig.3.2a
Fig.3.2b
5