Stihl iMOW RMI 522 C Installation page 2

Basic installation
ƒ
Positioning of internal docking station
and installation of perimeter wire
This quick guide should only be
used in combination with the instruction
manual for your mowing robot.
1. Before installation draw a sketch of the garden.
2. Install the docking station in a suitable location and charge the iMOW® in it.
3. Wake up the iMOW® by pressing the "OK" button and follow the instructions as
far as "Install wire".
4. Install the perimeter wire. Use the iMOW® Ruler and the corridor template to
establish the clearances.
5. Continue the installation with "Connect wire" and follow the instructions to the end.
Preparatory installation measures:
• Cut mowing area to ≤ 6 cm using a conventional lawn mower.
• Mowing areas must not overlap. Minimum clearance ≥ 1 m between the perimeter wires.
• Maximum distance between iMOW® robotic mower and perimeter wire: 17 m.
• Set iMOW® cutting height. Recommendation: Cutting level 4.
• The removal of interference sources such as metals is recommended.
9.1/9.5/9.9
Docking station position: Installing the perimeter wire:
• Shady, protected, level Install the perimeter wire (1) above ground at
• Clearance to no-go area: ≥ 2 m regular intervals and fasten using fi xing pins (2).
• Socket with overvoltage protection Use additional fi xing pins on uneven ground.
is recommended. Install wire without crossover.
9.1/12.9 12.3
Support: https://support.stihl.com/
Instruction manual Perimeter wire
The STIHL iMOW® robotic mowers
comply with all applicable safety
standards.
Nevertheless, the iMOW® robotic
mower is not a toy. During the iMOW®
robotic mower's active times, in
particular children, bystanders and
animals must be kept out of the working
area.
Accessory AKM 100 for small gardens:
For perimeter wire lengths ≤ 80 m.
9.9
Correct installation of wire connectors:
Insert loose, unstripped wire ends to the stop
in the wire connector. Press the wire connector
together using suitable pliers – ensure correct
engagement.
12.16
iMOW® Ruler Corridor template
!
Solid obstacle:
Is detected by
impact sensor.
4.1
Non-travellable
area:
• Clearance: 28 cm
• Obstacle height:
> 1 cm
12.5
100 cm
Pond:
Clearance: 100 cm
12.1
90°
Acute corners:
Angle: ≥ 90°
12.6
Adjoining travellable area:
• Clearance: ≥ 0 cm
• Terrain level relative to turf: < +/- 1 cm
12.5
28 cm
≥ 44 cm
No-go area:
• Clearance: 28 cm
• Install the wire in a circle without crossing it over
12.9
Internal docking station:
• Route wire 60 cm to the
side at an angle of 90°
• Free, level area in front of
docking station: 1 m radius
9.1
100 cm
≥ 60 cm
90°
90°
≥ 60 cm