Installing The Satellite System On/Off Switch; Ew-Sw100 / Ew-Sw300 - Shimano Steps BT-E6000 Dealer's Manual
Special battery and parts
Hide thumbs
Also See for BT-E6000:
- User manual (32 pages) ,
- Original instructions manual (69 pages) ,
- Dealer's manual (57 pages)
Table of Contents
Advertisement
Installation/removal
Installing the satellite system ON/OFF switch
(2) Close the charging port cap, and secure the satellite charging port.
(1)
Charging port cap
NOTICE
• Section A in the figure is part of the charging port cap. When installing the
satellite charging port, be careful that section A is not pinched by the frame.
Installing the satellite system ON/OFF switch
EW-SW100 / EW-SW300
NOTICE
• The work procedure and tightening torque may vary depending on the design of the
frame. Contact a distributor for details.
1.
Connect the electric wire of the satellite system ON/OFF switch.
• The electric wire may need to be connected after installing the satellite system ON/OFF
switch, depending on the design of the frame.
(2)
Section A
49
0.6 N·m
Mounting screw
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the BT-E6000 and is the answer not in the manual?
Questions and answers
can you re-set a e6000 bms because of the battery has been kept in a freezing condition