Table of Contents
Advertisement
18 Settings
18.1 Dialogs and menus
18
Settings
18.1
Dialogs and menus
Special Funct.\SYSTEM settings\Dialogs/Menus
• Select the menu item Dialogs/Menus.
• Press ENTER.
Notice!
The settings will be stored at the end of the dialog. If the menu item is quit by pressing BRK, the changes will not be
stored.
18.1.1
Pipe circumference
Special Funct.\...\Dialogs/Menus\Pipe Circumfer.
• Select on if the pipe circumference is to be entered instead of the pipe diameter in the program branch Parameter.
• Press ENTER.
Special Funct.\...\Dialogs/Menus\Pipe Circumfer.\Outer Diameter
If on is selected for Pipe Circumfer., the outer pipe diameter will still be requested in the program branch Parameter.
• In order to select the menu item Pipe Circumfer., enter zero.
• Press ENTER.
The value displayed in Pipe Circumfer. is calculated on the basis of the last displayed value of the outer pipe diameter.
Example: 100 mm · π = 314.2 mm
• Enter the pipe circumference. The limits for the pipe circumference are calculated on the basis of the limits for the outer
pipe diameter.
• Press ENTER.
During the next scroll through the program branch Parameter, the outer pipe diameter that corresponds to the entered
pipe circumference will be displayed.
Example: 180 mm : π = 57.3 mm
Notice!
The edition of the pipe circumference is only temporary. When the transmitter switches back to the display of the pipe
circumference (internal recalculation), slight rounding errors may occur.
Example
entered pipe circumference: 100 mm
displayed outer pipe diameter: 31.8 mm
When the transmitter switches back to the display of the pipe circumference, 99.9 mm will be displayed.
152
FLUXUS G801
2020-06-26, UMFLUXUS_G801V1-0EN
Advertisement
Table of Contents
