D-Link DCS-8302LH User Manual page 19

Section 3 - mydlink
1 Device Name
2 Privacy Mode
Motion and Person
3
Detection
4 Siren Timeout
5 Storage
6 Camera Microphone
7 Night Vision
8 Anti-Flicker
9 Status LED
10 Designated Contact
11 Wi-Fi
12 Time Zone
13 Firmware
14 MAC ID
15 Remove Device
D-Link DCS-8302LH User Manual
Tap to change the device's name.
Tap to enable. Privacy mode will disable the camera feed.
Tap to set the Motion and Person Detection area and sensitivity settings.
Set the auto-off timer for the siren. This setting will apply to manual
operation and Automations.
Tap to change the video clips storage location from the microSD card to the
cloud. You can also subscribe to mydlink Cloud from here and view your
current subscription plan.
Tap to enable or disable picking up sound near your camera in live view
and recordings.
Tap to change night vision detection to On, Off or Auto.
Reduces flicker in the video. Tap 50 Hz or 60 Hz depending on the frequency
of your lights.
Disabling this will turn off the LED until you turn it back on.
Tap here to add, remove, or edit designated contacts that appear in the
rich notification.
Tap to change the wireless network this device will use to connect
to the Internet. Note: The network must be the same as all your
other mydlink devices that you wish to use the same account for.
Select the time zone to calibrate your device to.
This displays the installed version of the firmware on your device. Tap to enter
the update settings. You can choose the most suitable time for automatic
updates.
Identifies the device for support issues.
Tap this button to disconnect this device from your mydlink account.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16