Page 2
Thank You Thank you for purchasing a Haier THERMOCOOL Product. Please read these instructions carefully before using this appliance. The instructions con- tain important information which will help you get the best out of the appliance and ensure safe and proper installation, use and maintenance.
Safety information Before switching on the appliance for the first time read the follow- ing safety hints! WARNING! Before first use ▶ Make sure there is no transport damage. ▶ Make sure all transport bolts are removed. ▶ Remove all packaging and keep out of children´s reach. ▶...
Page 5
Safety information WARNING! Daily use ▶ Do not remove or insert the plug in the presence of flammable ▶ Do not hot wash foam rubber or sponge-like materials. ▶ Do not wash any laundry which is polluted with flour. ▶ Do not open detergent drawer during any wash cycle. ▶...
Page 6
Safety information WARNING! Installation ▶ Install or use the appliance only where the temperature is above 5 °C. ▶ Do not place the appliance directly on a carpet, or close to a wall or furniture. ▶ Do not install the appliance in direct sunlight or in the near of heat sources(e.g.
Control panel 13 12 11 Cotton Express 15min Cotton+ Fast Delicate/ Synthetic Silk Hand wash Jeans Hygienic Sport Babycare Wool Spin Start/ Spin Extra Power Program Temp. Delay Pause speed rinse Function buttons: Indicators: 1 Detergent /Softener drawer 5 “Temp.” Extra rinse indicator 6 “Spin speed”...
Page 9
-in case of only one option- the LED switches off. 3.5.1 3.5.2 3.5.3 3.5.4 Note: Factory settings To get best results in each programme Haier has well defined specific default settings. If Cotton Express Cotton Express there is no special requirement default settings are recommended.
Page 10
Control panel laundry will not spun. In conjunction with the “Temp.” button, the child lock function can be switch on/off (see CHILD LOCK). Express 15min 3.5.3-Function button “Delay” Fast 3-5.3 3-5.4 Delicate/ Press this button (Fig. 3-5.3) to start the programme Silk Hand with a delay.
Page 11
Programmes Detergent compartment for: Water inlet only, no detergent Detergent Softener or care product • Yes, Optional, º Max. load Temperature Preset spin speed in kg in °C in rpm HW60/ HW70/ HW80/ seletable Programme HW100 range 1 Fibre type •...
Daily use 6.1 Power supply Connect the washing machine to a power supply (220V to 240V~/50Hz; Fig. 6-1). Please refer also to section INSTALLATION. 6.2 Water connection ▶ Before connecting check the cleanliness and clar- ity of the water inlet. ▶...
Page 13
Daily use Care chart Washing Washable up to 95°C Washable up to 60°C Washable up to 60°C normal process normal process mild process Washable up to 40°C Washable up to 40°C Washable up to 40°C normal process mild process very mild process Washable up to 30°C Washable up to 30°C Washable up to 30°C...
Page 14
Daily use 6.5 Selecting detergent ▶ Washing efficiency and performance is determined by used detergent quality. ▶ Use only machine wash approved detergent. ▶ If needed use specific detergents, e.g. for synthetic and woolen fabric. ▶ Mind always detergent manufacturer recommendations. ▶...
Page 15
Daily use 6.6 Adding detergent 1. Slide out the detergent drawer. 2. Put the required chemicals into corresponding compartments (Fig. 6-6) 3. Push back the drawer gently. Note: ▶ Remove detergent residues before next wash cycle from the detergent drawer. ▶...
Page 16
Daily use 6.10 Start wash programme 6-10 Start/ Press “Start/Pause“ button (Fig. 6-10) to start. Appli- Pause ance operates according to present settings. Changes are only possible by cancelling the programme. 6.11 Interrupt - cancel wash programme To interrupt a running programme press gently “Start/Pause“. The LED in the button is flashing.
Eco-friendly washing Environmentally responsible use ▶ To achieve best use of energy, water, detergent and time you should use the recom- mended maximum load size. ▶ Do not overload (hand width clearance above laundry). ▶ For slightly soiled laundry select the Quick Wash programme. ▶...
Care and cleaning 8.1 Cleaning the detergent drawer Take always care there are no detergent residues. Clean the drawer regularly (Fig. 8-1): 1. Pull out the drawer until it stops. 2. Press the release button and remove the drawer. 3. Flush the drawer with water until it is clean and insert the drawer back in the appliance.
Page 19
Care and cleaning 8.5 Long periods of disuse 8-5.1 8-5.2 If the appliance is left idle for a longer period: 1. Pull out the electrical plug (Fig. 8-5.1). 2. Turn off water supply (Fig. 8-5.2). 3. Open the door to prevent formation of moisture and odours.
Page 20
Care and cleaning 8-6.7 9. Clean carefully pump filter, e.g. using running water 8-6.8 (Fig. 8-6.7). 10. Refix it thoroughly (Fig. 8-6.8). 11. Close service flap. CAUTION! ▶ Pump filter sealing has to be clean and unhurt. If the lid is not full tightened, water can escape.
Page 21
Troubleshooting Many occuring problems could be solved by yourself without specific expertise. In case of a problem please check all shown possibilities and follow below instructions before you contact an after sales service. See CUSTOMER SERVICE. WARNING! ▶ Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket.
Page 22
Troubleshooting Problem Cause Solution • Motor - error. • Contact the After sales service. FC0, FC1 or • Abnormal communication error. • Contact the After sales service. • Unbalanced load - error. • Check and balance laundry load in the drum. Reduce the load.
Page 23
Troubleshooting Problem Cause Solution Automatic adjust- • Washing programme duration will • This is normal and doesn‘t af- ment of washing be adjusted. fect functionality. time. Spinning fails. • Unbalance of laundry. • Check machine load and laun- dry and run a spinning pro- gramme again.
Installation 10.1 Preparation ▶ Take the appliance out of the packaging. ▶ Remove all packaging material including polystyrene base, keep them out of childrens reach. While opening the package, water drops may be seen on plastic bag and port- hole. This normal phenomenon results from water tests in the factory. Note: Packaging disposal Keep all packaging materials out of children´s reach and dispose them in an environmen- tally friendly manner.
Page 25
Installation 3. Replace back cover by inserting it in the two gaps 10-3.3 10-3.4 its convexity is facing out (Fig. 10-3.3). 4. Fill left holes with blanking plugs (Fig. 10-3.4). Note: Keep in safe place Keep the transportation bolts in a safe place for later use.
Page 26
Installation 10.6 Drain Water Connection Fix the water drain hose properly to the piping. The hose has to reach at one point a height between 80 and 100 cm above the appliance bottom line! If possible keep always drain hose fixed to the clip at the appliance back. WARNING! ▶...
Page 27
Installation 10.7 Fresh Water Connection 10-7.1 10-7.2 Make sure that the gaskets are inserted. 1. Connect the water inlet hose with the angled end to the appliance (Fig. 10-7.1). Tighten the screw joint by hand. 2. The other end connect to a water tap with a 3/4“ thread (Fig.
Page 28
Technical data 11.2 Additional technical data HW60-12829* HW70-12829* HW80-12829* HW100-12829* HW60-14829* HW70-14829* HW80-14829* HW100-14829* Dimension in mm Height Width Depth Voltage in V 220-240 V~/50Hz Current in A Max power in W 2050 Water Pressure 0.03≤P ≤1 in MPa Max. water inlet- cold temperatur Netto weight in kg...
Need help?
Do you have a question about the HW60-12829S and is the answer not in the manual?
Questions and answers