Lutron Electronics Vive HMS-0 Manual page 7

Vive
Range Diagrams
All wireless devices to be associated to the Vive hub must be within 22 m of the Vive hub and must be on the same
floor as the Vive hub.
Note: Vive hubs should be mounted greater than 3 m apart on the same floor.
Note: Lutron requires that the Vive hub not be installed above metal ceilings or tiles with a metal backing.
Note: A corporate Wi-Fi network can interfere with the Wi-Fi on the Vive hub. Where a corporate Wi-Fi network exists,
it is recommended to do the following:
• Connect the Vive hub to the corporate network using the Ethernet connection on the hub and disable Wi-Fi on
the hub.
Note: Vive hubs should be mounted greater than 3 m from a Wi-Fi router or access point.
Private Office
PowPak Dimming
Module
Maximum
Maximum
Setup, Monitor
and Control
Vive Hub
Range with multiple Vive hubs
22 m
Maximum
30 m
S P E C I F I C AT I O N S U B M I T TA L
®
Job Name:
Job Number:
HMS-0, HMS-1, HMS-2
Vive Hub RF
coverage
9 m
9 m
Maximum
1
22 m
Maximum
9 m
9 m
1 Maximum
30 m
30 m
22 m
Maximum
Model Numbers:
Conference Room
PowPak Dimming Module
1
Open Office
PowPak Relay Module
1
NOTE: Wireless sensors and controls must be located within
1
9 m of the associated control module.
• Metal ceiling grids must have a > 3 mm gap of non-metal
material which extends the entire length of the tile on at least
one edge. This is often achieved by foam spacers that are
used to prevent tile-to-tile rattling.
• Metal ceiling grids which are continuous (with no gap) or those
that are interlocked, must have a total surface area that is
less than 81 m
larger as long as there are non-metal sections bordering or
intersecting the metal sections.
3691044-04g 7 03.23.21
Personal Control
Pico Remote Control
Sensors
Radio Powr Savr
Occupancy Sensor
for each section. The overall space can be
2
Wireless Hub
Page
7