BEER Culinario Fire & Ice Operating Manual page 28

Message Cause
Hi Overtemperature, temperature above
the alarm limit from parameter
Lo Undertemperature, temperature below
the alarm limit from parameter
E1L Error on the sensor F1, short-circuit
E1H Error on the sensor F1, fault
E2L Error on the sensor F2, short-circuit
E2H Error on the sensor F2, fault
E3L Error on the sensor F3, short-circuit
E3H Error on the sensor F3, fault
E4L Error on the sensor F4, short-circuit
E4H Error on the sensor F4, fault
E5 Door open too long
E6 High pressure fault
E7 Low pressure fault
E10 External alarm
EP0 Internal error control display
EP1 Error in the parameter memory
EP2 Error in data memory
Pr Internal: test mode
rtc Error of the lower clock
Errors EP0 and EP1
controller is unlocked. The error
are displayed alternately with the currently measured temperature.
Should the options listed not be the cause of the error, please contact customer service.
Beer Grill AG
Allmendstrasse 7 Tel. +41 (0)56 618 7800
CH – 5612 Villmergen
Fax +41 (0)56 618 7849
disable the controller. Only when the error has been eliminated, the
EP0 (and EP2) can only be eliminated by repair. The errors
Beer Grill GmbH
Körnerstrasse 14 a
D – 79539 Lörrach
Measures
Control of the sensor F1
Control of the sensor F1
Control of the sensor F2
Control of the sensor F2
Control of the sensor F3
Control of the sensor F3
Control of the sensor F4
Control of the sensor F4
Close the door
Control: Condenser fan and dirt
System leaks, too little refrigerant
Repair control display
Check all parameters
Repair control unit
Disconnect the controller from the
mains plug for a moment. If the mes-
sage does not disappear -> Repair
Reset he clock. If the error does not
disappear -> Repair
Tel. +49 (0)71 61 659 876
Fax +49 (0)71 61 659 879
info@beergrill.com
www.beergrill.com
Seite 28