Goodnal STP ST041 Pre Treatment (Sigma 900 MAX All Weather Refrigerated Sampler) Vendor Manual
Basic programming setup
70
Q-Pulse Id VM373
18-C. Press
CHANGE CHOICE
to make the selection.
18-D. Press either
HIGH CONDITION
•
Flow Rate of Change and Rainfall are signals that only increase in value and do
not require Low Condition.
•
The external control signal (such as an external flow meter) must be configured in
the external equipment for the desired setpoint.
11:00 AM 21 - APR - 01
UPSET CONDITION:
18-E. Enter the desired high or low trigger point using the numeric keypad. Press
to continue.
11:00 AM 21 - APR - 01
ACCEPT
CANCEL
18-F. Enter the Deadband value or, if programming for Flow Rate Of Change or Rainfall,
enter a time interval when the flow or rainfall change must take place (refer to
relays programming on page
11:00 AM 21 - APR - 01
ACCEPT
CANCEL
18-G. Enter the number of bottles (out of the total set) to set aside for upset samples.
These will be the last bottles in the tray.
11:00 AM 21 - APR - 01
ACCEPT
CANCEL
18-H. Select the method of distribution, Sample Per Bottle or
Bottles Per Sample.
to select the desired channel to trigger from. Press
or
LOW CONDITION
UPSET SAMPLING:
HIGH TRIGGER POINT:
00000 in.
(USE NUMERIC KEYPAD)
100).
UPSET SAMPLING
DEADBAND:
0.000
(USE NUMERIC KEYPAD)
UPSET SAMPLING:
NUMBER OF BOTTLES
2
ENTER 1 — 4
Active 29/10/2013
.
UPSET SAMPLES
HIGH
CONDITION
LOW
CONDITION
UPSET SAMPLES
CLEAR
ENTRY
UPSET SAMPLES
CLEAR
ENTRY
UPSET SAMPLES
CLEAR
ENTRY
ACCEPT
ACCEPT
Alarm
Page 70 of 122